User manual NETGEAR GSM7248

[. . . ] No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. To register your product, get the latest product updates, or get support online, visit us at http://support. Trademarks NETGEAR, the NETGEAR logo, ReadyNAS, ProSafe, Smart Wizard, Auto Uplink, X-RAID2, and NeoTV are trademarks or registered trademarks of NETGEAR, Inc. microsoft , Windows , Windows NT , and Vista are registered trademarks of Microsoft Corporation. [. . . ] The Link State ID identifies the piece of the routing domain that is being described by the advertisement. The time since the link state advertisement was first originated, in seconds. This corruption can occur while an advertisement is being flooded, or while it is being held in a router's memory. This field is the checksum of the complete contents of the advertisement, except the LS age field. Field Options Description The Options field in the link state advertisement header indicates which optional capabilities are associated with the advertisement. The options are: • Q: This enables support for QoS Traffic Engineering. €¢ E: This describes the way AS-external-LSAs are flooded. €¢ MC: This describes the way IP multicast datagrams are forwarded according to the standard specifications. €¢ V: This describes whether OSPF++ extensions for VPN/COS are supported. Routing ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual Virtual Link Configuration Use the Virtual Link Configuration page to define a new or configure an existing virtual link. To display this page, a valid OSPFv3 area must be defined via the OSPFv3 Area Configuration page. Use Area ID to specify the Area ID portion of the virtual link identification for which data is to be displayed. Use Neighbor Router ID to specify the neighbor portion of the virtual link identification. Virtual links may be configured between any pair of area border routers having interfaces to a common (non-backbone) area. Use Hello Interval to specify the OSPFv3 hello interval for the specified interface in seconds. This parameter must be the same for all routers attached to a network. Use Dead Interval to specify the OSPFv3 dead interval for the specified interface in seconds. This specifies how long a router will wait to see a neighbor router's Hello packets before declaring that the router is down. This parameter must be the same for all routers attached to a network. Use Iftransit Delay Interval to specify the OSPFv3 Transit Delay for the specified interface. This specifies the estimated number of seconds it takes to transmit a link state update packet over the selected interface. Use Retransmit Interval to specify the OSPFv3 retransmit interval for the specified interface. [. . . ] The same concept can be extended to other switches and more instances of MSTP. Notification of Compliance C NETGEAR Wired Products Regulatory Compliance Information This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority. This product's firmware limits operation to only the channels allowed in a particular Region or Country. [. . . ]