User manual NETGEAR GA622T INSTALLATION GUIDE

[. . . ] Caution: To avoid damaging any components on the card, handle it by the edges, using your thumbs to push it securely into the PCI slot. Make sure the card is fully inserted into the slot to prevent the PC operating system from freezing at startup. If you are inserting the card into a 32-bit slot, part of the connector edge on the card remains undocked. This situation is normal and does not affect the operation of the card. [. . . ] Internet / World Wide Web Go to http://www. NETGEAR. com for the NETGEAR Web page. Defective or damaged merchandise can be returned to your point-of-sale representative. To register your product, get product support, or to obtain product information and NETGEAR product documentation, direct your Web browser to the http://www. NETGEAR. com Web page. · GearBoxTM for Adapters CD · Unshielded Twisted Pair (GA622T) Category 5 cabling 100 meters max 7. I will choose the driver to install. ", then click "Next". Installation Guide, Warranty & Owner Registration Card, and Support Information Card 10/100 Mbps RJ-45 connector 12. The model GA622T Gigabit Adapter installation for Windows XP is now complete. Install the Windows 2000 Network Driver Note: If the "Insert Disk" window opens and a message prompts you to insert your Windows CD-ROM at any time during the installation process, insert the Windows CD-ROM in Drive D (the CD-ROM drive) and click on "OK". A Found New Hardware Wizard dialog box will appear, indicating that Windows 2000 has found the adapter. Click "Next". GA622T Copper Gigabit Ethernet Card Installation Guide · Warranty & Owner Registration Card · Support Information Card 3 INSTALL NETWORK DRIVER This section explains how to install the Network Driver in various Microsoft Windows Operating Systems. Some versions of Microsoft Windows Operating System may respond with different dialog boxes, or the dialog boxes may open in a different sequence than those shown in this guide, but should prompt you for the same information. Before you proceed with the installation steps, decide on a name for your network and for each PC. The whole network must have the same workgroup name while each PC must have a unique name. These names can be entered by going to Start>Settings>Control Panel>Network and clicking on the Identification tab. You also need to have the Microsoft Windows Operating System CD-ROM and the GearBoxTM for Adapters CD ready to use in the installation process. Please refer to README file in GearBoxTM for Adapters CD and NETGEAR support website for latest FAQ and trouble-shooting information. July 2002 M 1 - G A 6 2 2 N A - 1 2. Select "Display a list of the known drivers for this devices so that I can choose a specific driver". The next Windows appears with the following adapter name : NETGEAR GA622T Gigabit UTP Adapter. Make sure NETGEAR GA622T Copper Gigabit Ethernet Card is highlighted, and then click "OK". 3. A message will appear describing the status of the device. © 2002 by NETGEAR, Inc. Microsoft®, Windows® and Windows NT® are registered trademarks of Microsoft Corporation. Other brand and product names are trademarks or registered trademarks of their respective holders. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. 7. The Model GA622T Gigabit Adapter installation for Windows 2000 is now complete. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help. T Install the Windows NT Network Driver Note: If the "Insert Disk" window opens and a message prompts you to insert your Windows CD-ROM at any time during the installation process, insert the Windows CD-ROM in Drive D (the CD-ROM drive) and click on "OK". Conformity is declared by the application of EN 55 022 Class B (CISPR 22). Canadian Department of Communications Radio Interference Regulations This digital apparatus (Model GA622T Copper Gigabit Ethernet Card) does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. Règlement sur le brouillage radioélectrique du ministère des Communications Cet appareil numérique (Model GA622T Copper Gigabit Ethernet Card) respecte les limites de bruits radioélectriques visant les appareils numériques de classe B prescrites dans le Règlement sur le brouillage radioélectrique du ministère des Communications du Canada. DC Operating Voltage 6. [. . . ]