User manual NETGEAR FVS318N

[. . . ] Technical Support Please refer to the support information card that shipped with your product. Com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. Com Trademarks NETGEAR and the NETGEAR logo are registered trademarks and ProSafe is a trademark of NETGEAR, Inc. microsoft , Windows , and Windows NT are registered trademarks of Microsoft Corporation. [. . . ] In the upper left of the Policy Editor window, click the New Document icon (the first on the left) to open a New Connection. Figure 5-9 Fill in the other options according to the instructions below. • Under Connection Security , verify that the Secure radio button is selected. €¢ Enter the LAN IP Subnet Address and Subnet Mask of the VPN firewall LAN; in this example, we are using 192. €¢ Check the Use checkbox and choose Secure Gateway Tunnel from the pull-down menu. €¢ From the first ID Type pull-down menus, choose Domain Name. Enter the FQDN address which the VPN firewall VPN Wizard provided; in this example, we are using gw1_local. €¢ From the second ID Type pull-down menu, choose Gateway IP Address and enter the WAN IP Gateway address of the VPN firewall; in this example, we are using 21. Figure 5-10 • • • • • From the Select Certificate pull-down menu, choose None. Click Pre-Shared Key to enter the key you provided in the VPN Wizard; in this example, we are using “r3m0+eC1ient. In Network Adapter select the adapter you will use; the IP address of the selected adapter will display. 1, August 2010 Virtual Private Networking ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual • • • In the left frame, click Security Policy to view the settings: no changes are needed. In the left frame, expand Authentication (Phase 1) and click Proposal 1: no changes are needed. In the upper left of the window, click the disk icon to save the policy. Testing the Connections and Viewing Status Information Both the NETGEAR VPN Client and the VPN firewall provide VPN connection and status information. This information is useful for verifying the status of a connection and troubleshooting problems with a connection. NETGEAR VPN Client Status and Log Information To test a client connection and view the status and log information, follow these steps. To test the client connection, from your PC, right-click on the VPN client icon in your Windows toolbar and choose Connect. 1, August 2010 5-11 ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual Within 30 seconds you should receive the message “Successfully connected to My Connections\gw1”. Figure 5-13 The VPN client icon in the system tray should state On: 2. To view more detailed additional status and troubleshooting information from the NETGEAR VPN client, follow these steps. €¢ Right-click the VPN Client icon in the system tray and select Log Viewer. [. . . ] 1, August 2010 B-3 ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual Note: The one-time passcode is time synchronized to the authentication server so that the OTP can only be used once and must be used before the expiration time. If a user does not use this passcode before it is expired, the user must go through the request process again to generate a new OTP. The user then proceeds to the Two-Factor Authentication login page and enters the generated one-time passcode as the login password. 1, August 2010 Two Factor Authentication Appendix C Related Documents This appendix provides links to reference documents you can use to gain a more complete understanding of the technologies used in your NETGEAR product. [. . . ]