User manual NETGEAR FVL328

[. . . ] c. Connect the Ethernet cable (A) from your Cable or DSL Modem to the FVL328 firewall's Internet port. a. b. Turn on the firewall and wait for the test light to stop blinking. [. . . ] By registering your product at www. NETGEAR. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. Statement of Conditions In the interest of improving internal design, operational function, and/ or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product( s) or circuit layout( s) described herein. equipment on the market and has been granted the right to test the series for compliance with the regulations. Voluntary Control Council for Interference (VCCI) Statement This equipment is in the second category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Read instructions for correct handling. Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. NETGEAR, INC. Support Information Phone: 1-888-NETGEAR (For US & Canada only) For other countries see your Support Information card. E-mail: Support@NETGEAR. com Website: www. NETGEAR. com EN 55 022 Declaration of Conformance This is to certify that the Model FVL328 Cable/ DSL ProSafe Firewall with Dial Back-Up is shielded against the generation of radio interference in accordance with the application of Council Directive 89/ 336/ EEC, Article 4a. [. . . ] The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Federal Office for Telecommunications Approvals has been notified of the placing of this *M-FVL328NA-0* M-FVL328NA-0 October 2002 [. . . ]