User manual NETGEAR FVG318

[. . . ] c. ProSafe Wireless 802. 11g Firewall Model FVG318 Turn off your computer. At the computer end only, disconnect the Ethernet cable (point A in the illustration) that connects your computer to the cable or DSL modem. 2. Restart your network in the correct sequence Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet. [. . . ] If after 2 minutes it is still on, see the Troubleshooting Tips in this guide. If not, make sure the Ethernet cable is securely attached to the wireless VPN firewall Internet port and the powered on modem. If the Wireless light is not lit, see the Troubleshooting Tips in this guide. LOCAL: A LOCAL light should be lit. D · C · · Now, Configure the FVG318 for Internet Access and Wireless Connectivity Use the Smart Wizard configuration assistant to configure the FVG318. With the FVG318 in its factory default state, your browser will display the NETGEAR Smart Wizard welcome page. Note: If you do not see this page, type http://www. routerlogin. net in the browser address bar and click Enter. If you still cannot connect to the FVG318, verify your computer networking setup. Your computer should be set to obtain both IP and DNS server addresses automatically, which is usually so. For help with this, please see the Reference Manual or animated tutorials on the Resource CD. Follow the Smart Wizard prompts to connect to the Internet and set up wireless connectivity. Click Done on the Success screen and, if prompted, click OK to finish and close the screen. 4. Verify wireless connectivity. Connect to the Internet or log in to the FVG318 from a computer with a wireless adapter. For wireless connectivity problems, see the Troubleshooting Tips below or in the Reference Manual on the CD. Note: The configuration wizard only appears when the FVG318 is in its factory default state. [. . . ] To register your product, go to: http://www. NETGEAR. com/register Go to http://www. NETGEAR. com/support for support information. This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union, this product should be treated and recycled in accordance with the laws of your jurisdiction implementing the WEEE Directive. · Make sure the computer & router wireless settings match exactly. The Wireless Network Name (SSID) and security settings (WEP/WPA, MAC access control list) of the FVG318 and wireless computer must match exactly. August 2005 ©2005 by NETGEAR, Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. [. . . ]