User manual NETGEAR FS116P Installation Guide

[. . . ] Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described here in. Introduction Certificate of the Manufacturer/Importer It is hereby certified that the NETGEAR Model FS116P ProSafe 16 Port 10/100 Desktop Switch with 8 Port PoE has been suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992. [. . . ] Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferences in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interferences to radio communications. However, there is no guarantee that interference will not occur in a particular installation if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Power over Ethernet (PoE) EN 55 022 Declaration of Conformance This is to certify that the NETGEAR Model FS116P ProSafe 16 Port 10/100 Desktop Switch with 8 Port PoE is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN35 022 Class A (CISPR 22). Canadian Department of Communications Radio Interference Regulations This digital apparatus (NETGEAR Model FS116P ProSafe 16 Port 10/100 Desktop Switch with 8 Port PoE) does not exceed the Class A limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations o f the Canadian Department of Communications. Power over Ethernet (PoE) integrates power and data onto one single cabling infrastructure, eliminating the need to have AC power adapters available at all locations. The IEEE 802. 3af standard defines how products should provide and receive power over the data infrastructure. Using category 5/5e cable or better, PoE will provide power to PoE compatible devices, such as IP telephones, wireless LAN access points and IP cameras, for a distance up to 100 Meters. Products that are powered by PoE are generically called Powered Devices (PD). [. . . ] Support Information Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support See Support Information card for other countries. E-mail: support@NETGEAR. com (24 x 7 online support) www. NETGEAR. com By registering your product at www. NETGEAR. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH YOUR PRODUCT. Technical Support Fast Ethernet Switch FS116 MODEL 201-10536-01 P July 2005 Installation Guide ProSafe 16 Port Switch with 8 Port PoE 10/100 Mbps FS116P [. . . ]