User manual NETGEAR AX743-10000S

[. . . ] 74w with Fiber 182 years (at 25ºC); 46 years (at 55ºC) Insert the adapter into one of the available module bays, pressing firmly to seat the module. Once the adapter is seated, tighten the two set screws to hold the adapter in place. [. . . ] When there is active traffic across the fiber cable, the LED will blink to reflect the activity. Once loose, remove the adapter by holding the screw posts and pulling evenly on the adapter and sliding it out of the module bay. The switch may remain powered-on when installing or removing the adapter. After installing your device, locate the serial number on the label of your product and use it to register your product at http://www. Registration is required before you can use our telephone support service. For Warranty and Regional Customer Support information, see the Warranty Card that came with your product. regulatory Compliance The regulatory compliance details are documented below. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to change the product described in this document without notice. NETGEAR does not assume any liability that may accrue due to the use or application of the product(s) or circuit layout(s) described herein. Certificate of Manufacture/Importer It is hereby certified the NETGEAR model AX743 has been suppressed in accordance with the condition set out in MBPT-Amtsb|Vfg 243/1991 and vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with regulation may, however, be subject to certain restrictions. Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with regulation. [. . . ] NETGEAR and the NETGEAR logo are registered trademarks of NETGEAR, Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. [. . . ]