User manual NERO WAVE EDITOR 9

[. . . ] Manual Nero WaveEditor Copyright and Trademark Information Copyright and Trademark Information This document, like the software described therein, is provided as a license and may only be used or reproduced in accordance with the licensing agreement. The contents of this document, as well as the associated software, is subject to change without prior notice. Nero AG rejects any responsibility for the correctness of the contents of this document and rejects any claims that transcend the clauses of the guarantee agreement. This document and all of its contents are protected by copyright and are the property of Nero AG. [. . . ] Specifies the intensity of the right input signal for the left speaker. 6. 1. 8 Time Correction Tool The Time Correction tool changes the playback speed, but not the pitch. The following setting options are available in the Timescale Modification Factor area: Check box Percentage Check box Beats per Minute Drop-down menu Optimization Changes the playback speed in percent. The change can either be set on the slider or entered in the input field. Specifies the type of music of the audio file to be altered, so as to optimize speed changes for this file. Nero WaveEditor 28 Filters 6. 1. 9 Transpose Tool The Transpose tool changes the pitch. It is possible to adjust the length of the audio file to the faster playback speed. The following setting options are available: Slider Interval Slider Fine-tune Check box Maintain Original Length Changes the pitch in the audio file. Permits fine tuning if retaining the original length causes distortion. Retains the original length of the audio file. 6. 2 Effects 6. 2. 1 Chorus Effect The Chorus effect creates an echo effect, which when applied to a recorded voice, makes it sound like there is a choir singing in the background. The following setting options are available in the Modulation area: Slider Depth Slider Frequency Specifies the degree of the change in pitch. Specifies the frequency of the change in pitch (oscillations). The following setting options are available in the Delay area: Slider Delay Specifies the delay with which the copy is played in comparison with the original signal. The following setting options are available in the Filters area: Check box Low Pass Slider Low Pass Activates a low pass filter. Reduces frequencies above the specified Hertz rate and allows low frequencies beneath the specified value to pass almost unfiltered. The following setting options are available in the Mix area: Slider Effect Mixes the original signal with the copied signal, indicating the intensity of the copied signal. Nero WaveEditor 29 Filters Slider Dry Signal Mixes the original signal with the copied signal, indicating the intensity of the original signal. The following setting options are available in the Chorus area: Button Mono/Stereo Gives the processed part of the audio file a more "mono-like" or "stereo-like" sound respectively. 6. 2. 2 Convolution Reverb Effect The Convolution Reverb effect transfers the convolution reverb conditions of a reference file and adjusts the audio file to the relevant reverb conditions. The following setting options are available: Button Select Impulse Response Graph Impulse Response Gain Graph Gain Opens the source file for the impulse response from which the reverb effect for the audio file to be edited is generated. Displays the signal of the impulse response. The y-axis of the curve specifies the gain of the reverb effect in the diagram, while the x-axis shows the frequency. Switches between a linear and logarithmic scale for the limiting frequency graphic. Slider Pre-Delay Slider Dry Signal Slider Effect Specifies the length of time required by the sound to be deflected from an obstacle, thereby indicating the intensity of the echo. Mixes the original signal with the copied signal, indicating the intensity of the original signal. Mixes the original signal with the copied signal, indicating the intensity of the copied signal. 6. 2. 3 Delay Effect The Delay effect creates an echo using a copy of the original signal which is played back with a delay. The following setting options are available in the Delay area: Slider Delay Time Slider Feedback Specifies the delay in playing back the copied signal. Specifies how many copies of the original signal are to be made. Nero WaveEditor 30 Filters The following setting options are available in the Mix area: Slider Dry Signal Slider Effect Mixes the original signal with the copied signal, indicating the intensity of the original signal. Mixes the original signal with the copied signal, indicating the intensity of the copied signal. 6. 2. 4 Distortion Effect The Distortion effect is used for guitars. This means that a recording of acoustic guitar can be distorted to sound like an electric guitar. The following setting options are available in the Distortion area: Drop-down menu Method Slider Drive Slider Hardness Check box Pre-Filtering Slider Lower Cutoff Slider Upper Cutoff Post-Filtering Slider Lower Cutoff Slider Upper Cutoff Offers a variety of distortion options, e. g. This can only be adjusted if the Tube, Fuzz3 and Variable clipping entries have been selected in the Method drop-down menu. [. . . ] 22 Play Audio file . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Program Launching the Program. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 R Record Audio file . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]