User manual NEFF T29V35N0

[. . . ] Operating, installation and caring instructions T29P4N0 1 GB Operating, installation and caring instructions page 02 English Dear Customer, We thank you and congratulate you on your choice. This practical appliance, which is modern and functional, has been manufactured from top-quality materials which have been subjected to a strict quality control during the entire manufacturing process and have been carefully tested so that they will meet all your cooking needs. We strongly advise you to read through these simple instructions, so as to ensure that you get perfect results from the moment you first use this appliance. This booklet contains important information, not only on how to use the appliance, but also on maintenance and safety. [. . . ] The installation dimensions can be seen on the following page. 6 Dimensions in mm Chimney cooker hoods are to be installed in accordance with the installation instructions of the hood. On the furniture into which the appliance is to be installed, the plastic coating and/or veneer must have been treated with a heat-resistant adhesive, otherwise it may become distorted or peel off, especially on the narrow sides. The rough edges of the cut-out must be sealed using a watertight material. Prior to connection of the appliance, it must be checked that the appliance specifications comply with local connection requirements (gas type and pressure). Please also check for any special regulations of your local supply company. The specifications of this appliance are listed on the rating plates which are located on the underside of the gas hob. It must be installed and connected according to the currently effective installation conditions. Particular care must be taken to provide suitable means of ventilation. 7 Installation (for the installer) Installation must be made by a kitchen installation expert. Note: If you intend to have the gas hob welded into a stainless steel worktop, for safety reasons and in order to fully maintain the requirements of your Siemens warranty, we recommend that this type of installation be done solely through our designated partner: Bautek. The furniture below the countertop should have an opening for passage of the gas pipe and electric wires measuring at least 50x50 mm. Any eventual cabinet, resting on the worktop, at any of the two sides of the hob, and the upstand on the back of the hob, each must be at least 50 mm from the edge of the hob itself. In case of elements sold complete with cabinet, the instructions for installation of the cooker hob are provided in the manual for the cabinet. Apply the sealing gasket along the edge of the opening taking care to overlap the joints (picture 1). Fit hook B in angle iron A welded on the unit (picture 2) taking care to block it in the holes provided, depending on the thickness of the countertop (30 mm, max. Turn tab C and position it under the countertop, then tighten screw D. Trim, if necessary, the part of the gasket extending beyond the cooker hob. Picture 1 Picture 2 8 Picture 3 9 Electrical connection Prior to connection check the voltage and total output on the technical label affixed to the appliance. When connecting the appliance, ensure the earth wire is connected first and that all wires are connected to the correct terminals. This safety gas tube must be routed in such a way that it is not fed through hot areas and does not come into contact with any hot parts of the appliance, e. g. Installation of the tube must ensure that it runs freely and that it cannot come into contact with any movable parts of the kitchen cabinets, e. g. a drawer. 13 Caution Only switch on the circuit breaker or main switch once the appliance has been installed. The appliance must be installed in the furniture in accordance with these operating, installation and maintenance instructions. [. . . ] Cleaning the burner cap with caustic chemicals is just as damaging as using acids or paint stripper. Rough pan scourers or sand paper will ruin the surface just as scouring powder and glass wool do. Do not clean the pan stands in a dishwasher. The pan stands must be completely dry before they are replaced. Home troubleshooting You do not always need to call the After Sales Technical Assistance. Important note: Only authorised personnel from our After Sales Technical Department can carry out work on the gas and electrical supply systems. 23 What has gone wrong? Probable cause - Defective fuse. [. . . ]