User manual NEFF S717T80Y0E FULL

[. . . ] Dishwasher en Instruction manual S. . . en Table of contents no i t cur t sen I l aunam 8 Intended use . 53 4 Intended use en 8 Intended use e s u dedne t n I ■ ■ ■ This appliance is intended for use in the home and domestic environments. Use the dishwasher only in the home and only for its designated purpose: for washing domestic dishes. This appliance is intended for use up to a maximum altitude of 4000 metres above sea level. Keep children below the age of 8 years old at a safe distance from the appliance and power cable. [. . . ] If the AquaSensor is active, “clean” rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3–6 litres. If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Time display The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). You can change the time display in time or hours/minutes so that the remaining running time of the rinsing progamme appears in the display window “Ready at” (for example 15:20 hours) or “Ready in” (for example 3:25). 30 Operating the appliance en Sensor setting The programme sequence is optmised in Auto programmes with the aid of sensors. The sensors adjust the programme strength of Auto programmes depending on the amount and type of soiling. Standard: This setting is ideal for a mixed load and heavily soiled utensils, but also saves energy and water. Sensitive: This setting adjusts the programme strength for the effective removal of food remnants, even if the amount of soiling is low. Very sensitive: This setting adjusts the programme strength for difficult conditions of use, for example firmly dried on food remnants. This setting is recommended if using biological or eco detergents which contain lower amounts of active agents. The energy and water consumption is adjusted accordingly. extraDry The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) You can switch the extraDry function on or off. Note: When ExtraDry function is switched on, Eco drying is deactivated. Eco forecast When Eco forecast is activated, the average water and energy consumption of the selected programme is briefly displayed on the display window at the top @. AutoPowerOff (Switching off automatically after the end of the programme) f O rewoP o t uA To save energy, the dishwasher is switched off 1 minute after the programme ends. You can also change this setting. Possible settings are: ■ off: The appliance does not switch off automatically. ■ After two hours: The appliance switches off after 2 hours. 31 en Operating the appliance emotionLight (interior light) * t hg i Lno i t ome * depending on the features of your dishwasher The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. You can switch the interior light on or off. Infolight * t hg i Lo f n i Note: Note that when the door is open the interior light is automatically switched off after 1 hour. y a l p s i d t no r F * depending on the features of your dishwasher You can switch the front display ): on or off (additional programme information). Front display * * depending on the features of your dishwasher While the programme is running, a light spot shines on the floor under the appliance door. Do not open the appliance door until the light point is no longer visible on the floor. If the appliance door is not completely closed, the light spot flashes *. If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. You can switch the Infolight on or off. Changing start programme You can change the “Start programme” setting. Tone volume The end of the programme is indicated by a buzzer. Note: When Eco drying is switched on, the end of the programme is not indicated by an acoustic signal. TimeLight (Optical display while the programme is running) * t hg i Lemi t * depending on the features of your dishwasher While programme is running, an optical display (additional programme information) is indicated on the floor under the appliance door. If the base panel is pulled forwards or if the appliance is installed at eye-level with flush furniture front, the display is not visible. You can switch the optical display on or off. Button volume When you are operating the dishwasher, a signal sounds whenever a button is pressed. [. . . ] The appliance can easily be installed in a fitted kitchen between wooden and plastic walls. Drainage connection 1. The required work sequence can be found in the installation instructions. Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts. Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! 50 Installation and connection en Drinking water connection 1. [. . . ]