User manual NEFF S66M63N0GB

[. . . ] 9000 460 404 (8908) en Operating instructions n 9 10 Reset 3 sec. h. min. Start ABC 1 2 3 4 5 6 7 8 20 21 22 23 24 25 26 27 28 29 30 en en Table of contents Washing the dishes . 14 14 14 14 14 15 15 15 15 15 15 15 16 16 16 16 17 17 18 18 19 19 19 20 20 21 21 21 22 22 22 22 22 23 23 23 23 24 24 24 Safety instructions . 14 3 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] There is a slight increase in the energy consumption. Programme sequence indicator h -/, Your dishes are being cleaned. =/< Your dishes are being dried. 14 en Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display )". The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press P + or ­ button until the displayed time corresponds with your requirements. ­ To delete timer programming, press the P + or ­ button until )" : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Terminating the programme (Reset) ­ Press START button ` for approx. ­ Switch off ON/OFF switch (. Changing the programme When the START button ` has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). End of programme The programme has ended when the value : is indicated on the numerical display )". Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 15 en Intensive drying The final rinse uses a higher temperature which improves the drying result. ­ Hold down programme button # and press START button ` until the digital display )" : . . . The LED for button # flashes and the digital display )" displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display )". To change the setting, ­ Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. [. . . ] ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. Please note the system will not function unless the power supply is connected. Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: ­ Turn on the tap. [. . . ]