User manual NEFF S51U69X2EU

[. . . ] 37 yf tS e a This appliance is intended for use in the home and the home environment. Use the dishwasher only in the household and only for its designed purpose: for washing domestic dishes. Safety instructions sic nusi otrtn Installation and connection . 40 Children from 8 years of age or people whose physical, sensory or mental abilities or their lack of experience or knowledge prevent them from using the appliance safely must not use this appliance without supervision or instruction by a responsible person. Before you switch ON the appliance Please read the operating and installation instructions carefully. [. . . ] Hold down programme button # and press START button )" until : . . . . To delete timer programming `, press the + or – button until is indicated on the digital display X. You can change your programme selection at any time until the programme starts. Close the door. Remaining running time display When the programme is selected, the programme running time is indicated on the digital display 8. When the programme has started, the remaining running time is displayed on the floor (only for settings : and : ). The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). End of programme The end of the programme O / : is displayed on the floor – provided the optical display is switched on and is visible. Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . Press programme button # until the factory set value : is indicated on the digital display 8. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). Close the door. Timer programming You can delay the start of the programme in 1 hour steps up to 24 hours. Press the button ` + until is flaching in the timer programming display X. Press + or – button until the ` displayed time corresponds with your requirements. Press START button )", timer programming is activated. 23 en Operating the appliance To change the setting: 1. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . Close the door. Note Depending on the setting for “Automatic switch off when programme ends or interior light”, the optical display is no longer or only briefly visible. Automatic switch off after end of programme or interior light* Automaticswitchof /interiorlight * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. Hold down programme button # and press START button )" until : . . . The LED for button # flashes and the digital display 8 displays the factory setting : . 24 Switching off the appliance Short time after the end of the programme: 1. [. . . ] Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! 38 Installation and connection en Drinking water connection 1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts. Ensure that the drinking water connection is not kinked, crushed or twisted. Inlet rate: Minimum 10 litres/minute Water temperature: Cold water; hot water max. [. . . ]