User manual NEFF I89D55N0GB

[. . . ] Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. 04 mbar). Circulating-air mode: An activated carbon filter must be fitted for this operating mode (see Filters and maintenance). The complete installation set and replacement filters can be obtained from specialist outlets. The corresponding accessory numbers can be found at the end of these operating instructions. The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen. [. . . ] Insert the clean filters back into the hood. Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 6 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Even for some time after the bulbs have been switched off there is still a risk of burns. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. [. . . ] Ensure that the minimum distance between hotplate and extractor hood is 550 mm for electric hotplates and 650 mm for gas hotplates. ­ This is the height of the ceiling, the height of the base and the distance between the hob and extractor hood. Exhaust air 430 - 710 Circulating air 430 - 750 min. Screw together the upper and lower sections of the support frame at the specified overall height with 8 screws. Insert the extractor hood over the installation aids on the support frame. Exhaust air 430 ­ 710 Circulating air 430 ­ 750 09. [. . . ]