User manual NEFF D99W6N0GB

[. . . ] Installation instructions and how to use and look after your built-in cooker hoods D99W6N0 NEFF (UK) Ltd Fig. 1 ELECTRO 2 Instructions for use: Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. The grease filter absorbs the solid particles in the kitchen vapours. D When the extractor hood is operated in exhaust-air mode simultaneously with a different burner which also makes use of the same chimney (such as gas, oil or coal-fired heaters, continuous-flow heaters, hot-water boilers) care must be taken to ensure that there is an adequate supply of fresh air which will be needed by the burner for combustion. [. . . ] Installation and removal: Warning: The halogen bulbs must be switched off and cool. Remove the metal filter (see "Removing and inserting the metal grease filter"). Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 8 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! Clean the extractor hood with a hot soap solution or a mild window cleaner. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Observe the warranty regulations in the enclosed service booklet. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Even for some time after the bulbs have been switched off there is still a risk of burns. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Note: If the light does not function, check that the bulbs have been inserted correctly. 9 Installation Instructions: Important information Old appliances are not worthless rubbish. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. [. . . ] Connect the green and yellow (Earth) wire to the terminal in the plug marked `E' or with the symbol ( ), or coloured green or green and yellow. Connect the blue (Neutral) wire to the terminal in the plug marked `N' or coloured black. Connect the brown (Live) wire to the terminal marked `L', or coloured red. Electrical data: Are to be found on the name plate inside the appliance after removal of the filter frame. Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. [. . . ]