User manual NEFF D99W45N0GB

[. . . ] Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. Before using your appliance for the first time, please read these Instructions for Use carefully. They contain important information concerning your personal safety as well as on use and care of the appliance. Please retain the operating and installation instructions for a subsequent owner. [. . . ] Clean the extractor hood with a hot soap solution or a mild window cleaner. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Observe the warranty regulations in the enclosed service booklet. 9 Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Even for some time after the bulbs have been switched off there is still a risk of burns. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Note: If the light does not function, check that the bulbs have been inserted correctly. If you encounter a problem If an # appears in the display: See "Filters and maintenance" Section. If is not possible to operate the extractor hood: Disconnect the extractor hood from the mains electricity supply by pulling out the plug or switching it off at the main fuse box. If you have any questions or if a fault occurs, please call Customer Service. When you call, please quote the following: E-Nr. FD Enter the relevant numbers into the box above. (product no. ) and FD (production date) are shown on the nameplate which can be seen inside the extractor hood after the filter frame has been detached. The manufacturer of the extractor hoods accepts no liability for complaints which can be attributed to the design and layout of the pipework. 10 Installation Instructions: Important information Old appliances are not worthless rubbish. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. Minimum distance between electric hob and bottom edge of extractor hood: 550 mm, Fig. The extractor hood must not be installed over a solid fuel cooker ­ a potential fire hazard (e. g. flying sparks) ­ unless the cooker features a closed, non-removable cover and all national regulations are observed. [. . . ] Adjust the height and align horizontally with the adjusting screws. 233 471 112 mind 550 Elektro mind 650 Gas Note: Take into account any special accessories that are going to be fitted. Carefully pull the upper flue duct upwards and screw the sides to the fixing bracket with 2 screws. 08. Insert the upper flue duct (slots downwards) into the lower flue duct. Protect the cover panels from scratches, for example by laying the template used for marking the wall over the top edge of the lower section. [. . . ]