User manual NEFF D8985N0GB

[. . . ] How to use and look after your built-in cooker hoods D8985 NEFF (UK) Ltd Fig. 550 2 Instructions for use: Appliance description Chimney panelling Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. g. in doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Replacing the activated carbon filter: A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 9 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. None of the materials cause pollution to the environment and all can be recycled for use again. Please help to protect the environment and dispose of the packaging in an environment-friendly manner. You can obtain information about the best method disposing of old appliances and packaging from your dealer or local municipal council. The extractor hood can be used in either exhaust-air or recirculating mode. Minimum distance between electric hob and bottom edge of extractor hood: 550 mm, Fig. Additional notes concerning gas cookers: When installing gas hotplates, comply with the relevant national statutory regulations (e. g. [. . . ] The extractor hood should only be connected to an earthed socket that has been installed according to relevant regulations. If possible, site the earthed socket directly behind the chimney panelling. We reserve the right to construction changes within the context of technical development. Changing over from exhaustair to recirculating mode Changing the electronic control system to recirculating mode: The standard factory setting is for operation in exhaust-air mode. To change the mode, the extractor hood must have been connected up and should be switched off. Electrical data: Are to be found on the name plate inside the appliance after removal of the filter frame. Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. [. . . ]