User manual NEFF D8600N0GB

[. . . ] Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. 04 mbar). Circulating-air mode: An activated carbon filter must be fitted for this operating mode (see Filters and maintenance). The complete installation set and replacement filters can be obtained from specialist outlets. The corresponding accessory numbers can be found at the end of these operating instructions. The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen. [. . . ] They can therefore be disposed of as household refuse. Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. 6 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Clean the sliding switch with a soft, damp cloth (mild detergent solution) only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). 5. Plug the appliance into the mains or switch it on at the fuse box. 7 Installation Instructions: Important information Old appliances are not worthless rubbish. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. Minimum distance between electric hob and bottom edge of extractor hood: 550 mm, Fig. The extractor hood must not be installed over a solid fuel cooker ­ a potential fire hazard (e. g. [. . . ] Before the 4 screws are tightened down, align the extractor hood properly. Stainless steel model: Remove the protective film from the two flue ducts. Take care not to damage the stainless steel surfaces which are susceptible to scratches etc. Screw the upper flue duct to the sides of the fixing bracket with 2 short screws. 13. [. . . ]