User manual NEFF D4972X0

[. . . ] de en fr nl it es el Gebrauchs- und Montageanweisung Operating and installation instructions Notice de montage et d'utilisation Gebruiks- en montageaanwijzing Istruzioni per l'uso e l'installatore Instrucciones de uso y montaje fr nl it es el de en de en fr nl Seite page page pagina 03 ­ 15 16 ­ 28 29 ­ 41 42 ­ 54 it es el pagina página 55 ­ 67 68 ­ 80 81 ­ 93 Abb. EL. 2 Operating instructions: Description of appliance Operating modes This can be achieved if the combustion air is able to flow through non-lockable openings, e. g. in doors, windows and in conjunction with an air supply/air-intake wall box or by other technical procedures such as reciprocal interlocking. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Depress the catches on both sides of the filter and remove the activated carbon filter. Replacing the activated carbon filter: A replacement filter can be obtained from any authorized dealer (see optional accessories). Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants and can be disposed of with domestic refuse. Inserting the filter: Warning: The halogen bulbs must be switched off and cool. Remove the metal-mesh filters (see "Removing and inserting the metalmesh grease filters"). Insert the activated carbon filter. 20 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the extractor hood with a hot soap solution or a mild window cleaner. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Even for some time after the bulbs have been switched off there is still a risk of burns. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Restore the power by inserting the mains plug or switching on the fuse. Note: If the light does not function, check that the bulbs have been inserted correctly. 21 Installation Instructions: Important information Old appliances are not worthless rubbish. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. [. . . ] Screw in the adjusting screws by hand until the extractor hood is situated on the base of the cupboard. 5. Screw the wall cover to the wall cupboard. Align the extractor hood in the cupboard. Re-insert grease filter (see Operating instructions). 26 Fitting into wall cupboard Note: The extractor hood housing can be clad inside the wall cupboard (e. g. If so, observe the following: The intermediate base must not be placed on the extractor hood housing. [. . . ]