User manual NEC WPA001

[. . . ] WMS Guide For Hardware Settings 507100-02-09-W-E-111105-01 Copyright © 2005, NewSoft Technology Corp. No portion of this document may be copied or reproduced in any manner without prior written permission from NewSoft Technology Corp. [. . . ] From the Windows Control Panel, open Network Connections, click Local Area Connection, and then click Properties. You will see the following dialog box. 1 Starting up the WMS b. Click Internet Protocol (TCP/IP) and change the IP address to a number between 192. 168. 168. 2 and 192. 168. 168. 254. Type 255. 255. 255. 0 for the Subnet mask. Example of an IP Address 2 Starting up the WMS 3. Use your Internet browser to open http://192. 168. 168. 30/ to see the configuration page for the WMS Receiver Box. Type "admin" as User name, and "1234" for Password. You must disable your firewall and proxy settings. If the configuration page doesn't open, turn the device off and on to reset it. 3 Setting up the WMS Chapter 2 Setting up the WMS The main menu has all the controls for configuring your WMS 100. Status Under Status, you can view the current settings of the Ethernet LAN or WLAN. Click General and LAN to see the Device Information and LAN Settings, including the MAC and IP address. WLAN settings can be seen by clicking WLAN. · The Region setting will tell you if 802. 11a Ad-hoc mode is supported or not. · The Link Status may be Up, indicating that it is connected to a WMS Sender, or Down, indicating that it is available for connecting. 4 Setting up the WMS Setup Under Setup, you can choose LAN or WLAN. · If you select DHCP, you have to find the IP address by using another tool or by asking your MIS department if you ever need to reconfigure. An alternative would be to push and hold the Reset button on the WMS Receiver Box for more than 5 seconds to revert to the factory default IP address. [. . . ] Only English alphanumeric characters are accepted for passwords. 7 Setting up the WMS Download WMS Click to download the WMS software. The program will be installed immediately. Site Survey This function is used to connect to any other SSID groups, especially Access Point. 8 [. . . ]