User manual NEC SHIELDPRO FC-N21S

[. . . ] NEC Ruggedised Notebook Computer FC-N21S User's Manual Shortcut to Table of Contents Information in this document is subject to change without notice. No part of this manual may be reproduced in any form without the prior written permission of NEC Australia. Microsoft and Windows are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. Intel, Intel Core, and Intel SpeedStep are registered trademarks or trademarks of Intel Corporation or their affiliate companies in the United States and other countries. [. . . ] Connecting the modem to lines other than the subscriber phone line may cause the modem to operate improperly or the modem and/or ShieldPRO to be damaged. If a modular cable is connected to the RJ-11 connector (phone line modular connector) on ShieldPRO, do not pull the modular cable nor move ShieldPRO. Failure to follow this instruction may cause the RJ-11 connector to be damaged. Connecting a modular cable to the LAN connector may cause a fault to occur. Ensure that the correct cable is connected to the RJ11 or LAN port. 1. Insert one end of the modular cable to the RJ-11 connector (modular connector for phone line) on ShieldPRO. Insert the other end of the modular cable to a modular jack on a nearby wall. Confirm that "Australia" is selected in field [Country/Region] and enter digits in the [Area Code] field. Enter the settings for the dialup connection depending on used applications (including Internet Explorer and Hyper Terminal). NEC ShieldPRO FC-N21S Ruggedised Notebook Computer User's Guide 0318-00002 Ver. 2. 0 Dec 2008 ­ Page 52 5. 12. 2. LAN The built-in 1000BASE-T LAN module allows ShieldPRO to connect with a network. The module supports the data transfer rate of up to 1000 Mbps. Do not remove the LAN cable from the hub while ShieldPRO is operational. If the LAN cable is removed during network connection, immediate re-connection may recover the operation. During network communication through a LAN, connect the AC adapter to ShieldPRO. This is to avoid unexpected shutdown while using LAN due to a lack of charge in the battery. During network communication, do not enter ShieldPRO into suspend (standby) or hibernate state. Always ask a system administrator whether a network application may be used in suspend (standby) or hibernate state. Some applications may cause data to be lost when ShieldPRO is recovered from suspend (standby) or hibernate state. 5. 12. 2. 1. Connecting ShieldPRO to network To connect ShieldPRO to network, a LAN cable sold separately is required. 1. Insert one end of a LAN cable to the RJ-45 connector (LAN connector) on ShieldPRO. Double-click [Local Area Connection] to display the [Local Area Connection Status] dialog box. Enter the settings appropriate for the connected network. NEC ShieldPRO FC-N21S Ruggedised Notebook Computer User's Guide 0318-00002 Ver. 2. 0 Dec 2008 ­ Page 53 If you do not know the necessary system settings to be used, contact a system or network administrator. 5. 12. 2. 3. [. . . ] Insert a thin needle-shaped wire such as extended paper clip into the manual ejection hole on the drive and push the wire hard. External floppy disk drives 1 The floppy disk drive indicator remains ON. Confirm that the floppy disk is inserted properly. NEC ShieldPRO FC-N21S Ruggedised Notebook Computer User's Guide 0318-00002 Ver. 2. 0 Dec 2008 ­ Page 156 2 Writing data to the floppy disk is disabled. Action Confirm that the floppy disk has been formatted. [. . . ]