User manual NEC PLASMASYNC PX-42M3A

[. . . ] PlasmaSync Plasma Monitor User's Manual NEC Technologies Important Information Precautions Please read this manual carefully before using your NEC PlasmaSync - 42inch Plasma Monitor PX-42M3A and keep the manual handy for future reference. Warnings and Safety Precaution The NEC Multimedia monitor PlasmaSync 4200W is designed and manufactured to provide long, troublefree service. Never use solvents such as alcohol or thinner to clean the panel surface. For operating safety and to avoid damage to the unit, read carefully and observe the following instructions. Provide adequate space for ventilation to avoid internal heat build-up. [. . . ] of the United States. Mini D-Sub 15 Pin RGB Signal Composition Pin Assignments and Signal Levels for 15 pin RGB (Analog) 4321 10 9 8 7 6 15 14 13 12 11 5 Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Signal to be connected RED GREEN or Sync. on Green BLUE No Connection GND RED (GND) GREEN (GND) BLUE (GND) No Connection SYNC (GND) No Connection SDA H. sync SCL 12 Basic Operations POWER To turn the unit ON and OFF: 1. The monitor's POWER/STANDBY indicator will light up(green) when the unit is on. Press the POWER button (on the remote controller or the unit) to turn off. The monitor's POWER/STANDBY indicator turns red and the standby mode is set. VISUAL CONTROL TO adjust the picture's contrast: 1, Press and hold the CONTRAST v button for higher contrast. TO adjust the picture's brightness: 1, Press and hold the BRIGHT v button for a brighter picture. TO adjust the picture's color: 1, Press and hold the COLOR v button for more color saturation. TO adjust the picture's tint (NTSC only): 1, Press and hold the TINT v button for a greener tint. TO adjust the picture's sharpness: 1, Press and hold the SHARPNESS v button for a sharper picture. *If no key operation is made within five seconds, the OSM display will disappear. VOLUME To adjust the volume: 1. Press and hold the VOLUME v button (on the remote controller or the unit) to increase to the desired level. Press and hold the VOLUME w button (on the remote controller or the unit) to decrease to the desired level. MUTE To cancel the sound: Press the MUTE button on the remote controller to cancel sound; press again to restore. DISPLAY To check the settings: 1. If the button is not pressed for approximately three seconds, the menu turn off. 13 OFF TIMER To set the off timer: The off timer can be set to turn the power off after 30, 60, 90 or 120 minutes. The timer starts when the menu turns off. 30 60 90 120 0 OFF TIMER30 To check the remaining time: 1. When five minutes remain the remaining time appears until it reaches zero. OFF TIMER28 Canceling the off timer 1. The off timer is canceled. OFF TIMER0 Note: After the power is turned off with the off timer . . . When you are leaving home or do not plan to use the system for a long period of time, turn off the power of the monitor. 14 WIDE Operations Watching with a wide screen (manual) With this function, you can select one of four screen sizes. The screen size switches as follows: ZOOM NORMAL FULL STADIUM ZOOM size screen FULL size screen The picture is expanded in the horizontal and vertical direction, maintaining the original proportions. * Use this for theater size (wide) movies, etc. The image is expanded in the horizontal direction. * Images compressed in the horizontal direction ("squeezed images") are expanded in the horizontal direction and displayed on the entire screen. [. . . ] *2 Only when using a graphic accelerator board that is capable of displaying 848 480. * "IBM PC/AT" and "VGA" are a registered trademark of International Business Machines, Inc. * "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States. 36 Troubleshooting If the picture quality is poor or there is some other problem, check the adjustments, operations, etc. , before requesting service. [. . . ]