User manual NEC PLASMASYNC 42XM4-(MM)

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. NOTE: When you connect a computer to this monitor, use an RGB cable including the ferrite core on both ends of the cable. If you do not do this, this monitor will not conform to mandatory FCC standards. Attaching the ferrite cores: Set the ferrite cores on both ends of the DVI cable (not supplied), and both ends of the power cable (supplied). Use the band to fasten the ferrite core (supplied) to the DVI cable. DVI cable (not supplied) band band Connector core (small) core (small) Power cable (supplied) core (large) core (large) 3 Recommandations importantes Avertissement Ne pas utiliser dans une salle d'ordinateurs telle que définie dans la Norme pour la protection des ordinateurs électroniques/appareils de traitement des données ANSI/ NFPA75. DOC avis de conformation Cet appareil numérigue de la Classe A respecte toutes les exigences du Réglement sur le Matériel Brouilleur du Canada. REMARQUE: Pour raccorder un ordinateur à ce moniteur, procéder à l'aide d'un câble RGB à âme de ferrite aux deux extrémités. Sur les câbles DVI et les câbles d'alimentation électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas en conformité avec les exigences des standards FCC. Monter les tores en ferrite aux deux extrêmités du câble DVI (non fourni) et aux deux extrêmités du câble d'alimentation électrique (fourni). If this occurs, please set the refresh rate of the external equipment to 60Hz. To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz refresh rate) when sync polarity is "Sync on Green", set "RGB SELECT" to "MOTION". NOTE: · While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the picture or the fine picture because of errors in synchronization of your computer. It is recommended that the input signal should be VGA, wide VGA, or equivalent for 42VP4PA/42VP4DP-A. · The sync may be disturbed when a nonstandard signal other than the aforementioned is input. · If you are connecting a composite sync signal, use the HD terminal. · "IBM PC/AT" and "VGA" are registered trademarks of International Business Machines, Inc. [. . . ] · "IBM PC/AT" and "VGA" are registered trademarks of International Business Machines, Inc. · "Apple Macintosh" is a registered trademark of Apple Computer, Inc. [. . . ]