User manual NEC MT600

[. . . ] NEC Multimedia Theatre NEC Multimedia Theatre LCD Projector User's Manual R 600 NEC Technologies, Inc. 1250 N. Arlington Heights Road, Suite 500 Itasca, Illinois 60143-1248 Part No. 78406832 Printed in Japan IMPORTANT INFORMATION CAUTION TO PREVENT SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED NEC SERVICE PERSONNEL. Precautions Please read this manual carefully before using your NEC MultiSync MT600 LCD Projector and keep the manual handy for future reference. [. . . ] Si le filtre est sale ou bouché, votre projectuer peut surchauffer NOTE: Nettoyer votre filtre après 100 heures d'usage. Pour nettoyer le filtre à air: 1. Fermer le contact de courant du projecteur à écran à cristaux liquides (LCD) et attendre que le ventilateur arrête. Fermer le contact de courant principal et débrancher le câble électrique. Enlever le panneau du filtre en poussant sur le bas du couvercle jusqu'à ce que vous sentiez un détachement du couvercle. Remplacer avec un nouveau filtre ou nettoyer le filtre en place à fond avec un aspirateur. Ne pas laver le filtre avec de l'eau et du savon, L'eau et le savon vont endommager le membrane du filtre. 47 Getting To Know Your MultiSync MT600 LCD Projector Front Features Built-in speakers (1W Lens with Lens cover Carrying handle 2) Rear Features Lamp cover Remote sensor Remote sensor Lamp cover set screw One Touch Tilt buttons Remote Sensor AC INPUT Connect the supplied power cable' s three-pin plug here. Main POWER switch Ventilation holes(inlet) Feet INTRODUCTION 16 Top Features 1. Power Button Use this button to tu rn the power on and off when Main Power Switch is on and the LCD projector is on standby. (When this button is pressed and held for at least two seconds, the "Display Mute" mode will be canceled. ) 2. Menu Button Displays the icons you need to select a source or adjust your image. Select Button After your press the "Menu" button, use this button to select the menu icon of the item you wish to adjust. (If the icons don't appear after you press the "Menu" button, hold down the "Select" button while using the (+) (-) focus button to adjust the image up or down until the icons do appear. ) 4. Use these buttons to increase or decrease the level of a selected menu item. Zoom: Hold down the "Zoom" button while you press the (+) button to to make the image larger; or press (-) to make the image smaller. Focus: Hold down the "Select" button while you press the (+) or (-) buttons to focus an image. Power Indicator When this indicator is green, the LCD projector is on; when the indicator is amber, it is standing by. Status Indicator When this is lit red continually , it's warning you that the projection lamp has exceed 2000 hours of service. After this light appears, it is advisable to replace the projection lamp as soon as possible. (See page 41. ) 5. Installer une nouvelle ampoule et fixer le coffret de l'ampoule avec les deux vis. PRECAUTION: Ne pas utiliser d'autres ampoules que l'ampoule NEC en option. Faire la commande avec le numéro de modèle de votre projecteur. [. . . ] The Projector needs to cool down for a minute before it is powered on again. OPERATION 34 3 OPERATION This section describes how to select a computer or video source and how to adjust the picture and sound. General Controls Before you turn on your MultiSync MT600 LCD Projector ensure that the computer or video source is turned on and that your lens cap is removed. Turn On The LCD Projector The main power switch is on the back panel of the MultiSync MT600 LCD Projector. By turning this switch on, the projector will go into its standby mode and the power light will glow amber. [. . . ]