User manual NEC M46

[. . . ] product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding the warranty. Main switch cover (with stand) the longer side of the cover is toward the bottom of the display. Main switch cover (without stand) the shorter side of the cover is toward the bottom of the display. [. . . ] YEAR MONTH DAY TIME DAYLIGHT SAVING SCHEDULE RESET Resets the following settings within the SCHEDULE menu back to factory setting: OFF TIMER, SCHEDULE SETTINGS. Allows the monitor to remain in "PIP" mode after powering off. Selects the size of the sub-picture used in Picture-in-Picture (PIP) mode. Resets the following settings within the PIP menu back to factory setting: KEEP PIP MODE, PIP MODE, PIP SIZE, PIP POSITION. The information OSM will also give a warning when there is no-signal or the signal is out-of range. An interval between 3 to 10 seconds for the Information OSM to appear is available. OSM TRANSPARENCY OFF TYPE1 TYPE2 OSM RESET Resets the following settings within the OSM menu back to factory setting: OSM TURN OFF, OSM POSITION, INFORMATION OSM, and OSM TRANSPARENCY. Selects the mode of the monitor for use with the infra-red remote control when using the RS-232C daisy chain. the monitor will be controlled normally by wireless remote controller. Choose "PRIMARY" for the first monitor within an RS232-C daisy chain. Choose "SECONDARY" for all subsequent monitors within an RS232-C daisy chain. Resets the following settings within the MULTI DISPLAY menu back to factory setting: MONITOR ID, IR CONTROL, TILE MATRIX, POWER ON DELAY. Sets how long the monitor waits to go into power save mode after a lost signal. Use the SCREEN SAVER function to reduce the risk of Image Persistence. The gamma curve becomes narrow, reducing contrast and cutting down the risk of image retention. Resets the following settings within the Picture menu back to factory setting: POWER SAVE, STANDBY MODE, FAN CONTROL, SCREEN SAVER, SIDE BORDER COLOR, AUTO BRIGHTNESS. Selects the method of input detection the monitor uses when more than two input devices are connected. When the current video input signal is not present, then the monitor searches for a video signal from the other video input port. If the video signal is present in the other port, then the monitor switches the video source input port to the new found video source automatically. The monitor will not look for other video signals while the current video source is present. When the monitor is displaying a signal from the current source and a new secondary source is supplied to the monitor, the monitor will automatically switch to the new video source. When current video input signal is not present, the monitor searches for a video signal from the other video input port. [. . . ] This program may contain intense violence (V), intense sexual situations (S), strong coarse language (L), or intensely suggestive dialogue (D). This program may contain mature themes, indecent language, graphic violence and explicit sexual content. Using the LCD with RS-232C Use the wireless remote controller to control the "SECONDARY" monitor while aiming at the "PRIMARY" monitor. ID number assigned to current monitor ID number assigned monitor to be controlled via RS-232C Using the LCD with RS-232C - continued This LCD monitor uses RXD, TXD and GND lines for RS-232C control. [. . . ]