User manual NEC LT65

[. . . ] Portable Projector LT265/LT245 User's Manual Important Information Safety Cautions Precautions Please read this manual carefully before using your NEC LT265/LT245 Projector and keep the manual handy for future reference. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. REFER SERVICING TO QUALIFIED NEC SERVICE PERSONNEL. This symbol warns the user that uninsulated voltage within the unit may be sufficient to cause electrical shock. [. . . ] This will disconnect a LAN connection when the computer goes in standby mode. NOTE: To use the Desktop Control Utility 1. 0, you need to have a USB mouse inserted into the USB port of the projector. 57 4. · · For instructions on installation, refer to the included "NEC Software Utility Installation Guide". For instructions on operating the software, see the Desktop Control Utility 1. 0's help file. 3. Prepare the documents to be presented at the meeting and save them on the computer. The Startup password window appears. Window at the first startup Window after entering your startup password Important: · Your startup password will be required each time you start Desktop Control Utility 1. 0. The "Current password" input window appears. If you forget or lost your startup password, install the program again. NOTE: The "Current password" will be changed each time you start Desktop Control Utility 1. 0. Desktop Control Utility 1. 0 starts. Go to the room where the projector is installed, taking the password you made a note in the previous Step [6]. 58 4. Convenient Features Operations on the projector ­ Connecting to the computer 1. Make the LAN settings at [Setup] [Installation] [LAN Mode] in the menu. (See page 99) Connect a commercially available USB mouse to the projector. The message is displayed only when a password for Desktop Control Utility 1. 0 is not assigned. 5. Follow the message to press the MENU button on the projector cabinet or the remote control. 7. Click the password input icon Click "Entry". . The password input window appears. 8. Click . The character input window appears. Input the password you made a note of in the previous Step [6] in "Operations on the Computer". 10. To search by inputting the IP address of the connected computer, click "Input IP Address", then click "OK". Click the computer to which you want to connect, then click "OK". · on the PC Search window, click NOTE: Once the desktop appears, the menu will no longer appear when the USB mouse is clicked. To display the menu while the desktop is displayed, press the button on the projector itself or on the remote control. Operations on the projector ­Operating the desktop A USB mouse connected to the projector can be used to operate the displayed desktop. If the MENU button on the projector cabinet or the remote control is pressed while the desktop is displayed, an additional operations bar appears at the bottom left of the screen. 60 4. Convenient Features The following operations are available only with buttons on the projector cabinet or the remote control. Select this icon and press the ENTER button to set the shift lock mode. Select this icon and press the ENTER button again to cancel the shift lock mode. [. . . ] ANY OTHER DAMAGES, WHETHER INCIDENTAL, CONSEQUENTIAL OR OTHERWISE. HOW STATE LAW RELATES TO THE WARRANTY SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. Arlington Heights Road Itasca, Illinois 60143-1248 TELEPHONE 800-836-0655 WHAT NEC SOLUTIONS WILL PAY FOR NEC Solutions will pay labor and material expenses for covered items, but NEC Solutions will not pay for the following: 1. Costs of technical adjustments, set-up, maintenance, or adjustment of user controls. [. . . ]