User manual NEC LCD2490WUXI

[. . . ] This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit. This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems. [. . . ] When this function is activated, the brightness and contrast of the monitor can be adjusted by using the front buttons without entering the OSM menu. Selecting the factory preset allows the user to reset most of the OSM control settings back to the factory settings. This mode changes the display's screen image from color to grayscale. MANUAL: To rotate the OSM, press the ROTATE OSM button when the OSM is not showing. When the monitor is used in the portrait position, the brightness value will be reduced to 300 cd/m . DDC/CI ENABLE/DISABLE: Turns on or off the two way communication and control of the monitor. MOTION (Default OFF): Screen image moves periodically in 4 directions in order to reduce the risk of image retention. Timing for MOTION can be set so the screen image moves in intervals from every 10 to 900 seconds. REDUCED: Screen image is reduced to 95% size and is moved periodically in 4 directions. Screen image goes outside of the display area in the direction that it shifts so that a portion of the image may appear to be cut off. gAMMA (Default OFF): When OFF , the GAMMA selection that the display uses is the same as the GAMMA selection in Tag5 (page 20). When ON is selected, the GAMMA curve (except PROGRAMMABLE) becomes narrow, reducing the contrast and cutting down the risk of image retention. NOTE: SCREEN SAVER does not function when the TILE MATRIX function is enabled. vIDEO BAND WIDTH (Analog input only): Adjusts the bandwidth of the video signal. Try this option if the FINE adjustment does not successfully eliminate the noise. sOG THRESHOLD (Analog input only): Adjusts the sensitivity of the Sync On Green input signals. Adjusts the slice level when separating a synchronization from Sync On Green signal input. EDGE LOCK: Operating your monitor at a non-standard timing may cause images to appear darker than normal or to have color distortion. Use of the Edge Lock control will adjust images to their normal state. the "TILE MATRIX" feature allows one image to be displayed over multiple screens. (5 horizontal x 5 vertical) Using the Tile Matrix function requires the PC output signal to be sent through a distribution amplifier to each of the individual monitors. TILECOMP: Works in tandem with "TILE MATRIX" to compensate for the bezel width of the tiled monitors in order to accurately display the image. [. . . ] dedicated recycling sites ensure that environmentally harmful components are properly handled and securely disposed. To ensure the best recycling of our products, NEC DISPLAY SOLUTIONS offers a variety of recycling procedures and gives advice on how to handle the product in an environmentally sensitive way, once it has reached the end of its life. All required information concerning the disposal of the product and country-specific information on recycling facilities can be found on our following websites: http://www. Energy saving: This monitor features an advanced energy saving capability. [. . . ]