User manual NEC LCD205WXM

[. . . ] 48W (LCD225WXM) Less than 2W Less than 1W LED color Green Orange Unlit Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical and electronic products carrying the mark (left) must be disposed of separately from normal household waste. This includes monitors and electrical accessories, such as signal cables or power cords. When you need to dispose of your NEC display products, please follow the guidance of your local authority, or ask the shop where you purchased the product, or if applicable, follow any agreements made between yourself and NEC. [. . . ] * Type of power cord included will depend on the where the LCD monitor is to be shipped. To attach the MultiSync LCD monitor to your system, follow these instructions: Turn off the power to your computer. And China) to the connector of the display card in your system (Figure A. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A. Connect one end of the power cord to the monitor and the other end to the power outlet. Position the Video Signal Cable, Audio cable and power cord between the holes on the Stand. To attach the Cable management cover, insert the tabs of the Cable management cover into the holes on the Stand and slide the Cable management cover downward into place (Figure B. NOTE: Adjust the position of the cables that are placed under the Cable management cover to avoid damaging the cable or monitor. Please refer to the Caution section of this manual for proper selection of power cord. Turn on the monitor with the front power button and the computer (Figure C. For further adjustments, use the following OSD controls: · Refer to the Controls section of this User's Manual for a full description of these OSD controls. NOTE: If you have any problem, please refer to the Troubleshooting section (CD-ROM). To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (Figure RL. Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS. NOTE: Handle with care when tilting and swivelling the monitor screen. Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. Press "SELECT" key Press "SELECT" key Press "SELECT" key Adjust by using "­" or "+" Press "SELECT" key Adjust by using "­" or "+" Selecting TOOL allows you to get into the sub menu. [. . . ] NO SIGNAL: This function gives a warning when there is no signal present. After power is turned on or when there is a change of input signal or video is inactive, the No Signal window will appear. RESOLUTION NOTIFIER: This function gives a warning of use with optimized resolution. [. . . ]