User manual NEC ESERIES

[. . . ] NEC Enterprise Series MultiSync E Series User's Manual User's Manual Contents Quick Start Controls Recommended Use Specifications Features Troubleshooting References Limited Warranty 1 2-3 4-5 6-7 8-9 10 11 12 13 ® ® 78131861 1 5/21/98, 2:22 PM WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK · DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] · If possible, position the monitor so that it is facing the east to minimize the effects of the earth's magnetic field. · Changing the direction of the monitor while it is powered on may cause image discoloration. To correct this, turn the monitor off for 20 minutes before powering it back on. · The power cable connector is the primary means of detaching the system from the power supply. The monitor should be installed close to a power outlet which is easily accessible. Save packaging for transporting. Immediately unplug your monitor from the wall outlet and refer servicing to qualified service personnel under the following conditions: · · · · · When the power supply cord or plug is damaged. If the monitor does not operate normally by following operating instructions. 6 78131861 8 5/21/98, 2:23 PM Recommended Use CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: · Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. · Position your monitor no closer than 12 inches and no further away than 28 inches from your eyes. · Rest your eyes periodically by focusing on an object at least 20 feet away. · Position the monitor at a 90° angle to windows and other light sources to minimize glare and reflections. Adjust the monitor tilt so that ceiling lights do not reflect on your screen. · If reflected light makes it hard for you to see your screen, use an anti-glare filter. Use a lint-free, non-abrasive cloth and a non-alcohol, neutral, non-abrasive cleaning solution or glass cleaner to minimize dust. · Adjust the monitor's brightness and contrast controls to enhance readability. · Position whatever you are looking at most of the time (the screen or reference material) directly in front of you to minimize turning your head while you are typing. (Positive/Negative) (TTL Level) Unlimited number of Colors 31 kHz to 82 kHz 55 Hz to 120 Hz Depends on display card used. Automatically Automatically Display Colors Synchronization Range Analog input: Horizontal: Vertical: Resolutions Supported Resolution based on horizontal and vertical frequencies only 640 x 480 @ 60 to 120 Hz Some systems may not support 800 x 600 @ 55 to 120 Hz all modes listed. 832 x 624 @ 55 to 120 Hz 1024 x 768 @ 55 to 100 Hz . . . . . . . . . . . . . . . . . . . . . NEC cites recommended resolution at 1152 x 870 @ 55 to 89 Hz 85 Hz for optimal display performance. 1280 x 1024 @ 55 to 76 Hz 1600 x 1200 @ 55 to 65 Hz 306 mm/12. 0 inches 230 mm/9. 1 inches 316 mm/12. 4 inches 237 mm/9. 3 inches AC 100 ­ 120 V, 50/60 Hz 1. 8A @ 100 ­ 120 V 403 mm (W) x 426 mm (H) x 453 mm (D) 15. 9 inches (W) x 16. 8 inches (H) x 17. 8 inches (D) 19. 5 kg 43. 0 lbs 10°C to +35°C 30% to 80% 0 to 10, 000 Feet -20°C to +60°C 10% to 90% 0 to 45, 000 Feet NOTE: Technical specifications are subject to change without notice. [. . . ] All Products returned to NECTECH for service MUST have prior approval, which may be obtained by calling 1-800-632-4662. The Product shall not have been previously altered, repaired, or serviced by anyone other than a service facility authorized by NECTECH to render such service, the serial number of the product shall not have been altered or removed. The Product shall not have been subjected to accident, misuse, or abuse or operated contrary to the instructions contained in the User's Manual. NECTECH SHALL NOT BE LIABLE FOR DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, OR OTHER TYPES OF DAMAGES RESULTING FROM THE USE OF ANY NECTECH PRODUCT OTHER THAN THE LIABILITY STATED ABOVE. [. . . ]