User manual NADY CM-2S

[. . . ] CM-2S Stereo Condenser Microphone USER GUIDE Congratulations on purchasing the Nady CM-2S Stereo Condenser Microphone. [. . . ] All this contained in a compact, lightweight design for easy camera mounting The CM-2S has two unbalanced, in-phase, low impedance stereo outputs. The Left(+) signal is sent to Pin 2 and the Right(+) signal is sent to Pin 3. Use the 19" stereo cable to connect to 3. 5mm stereo inputs or the 10'cable to connect to two channels of your mixing console or recording equipment. Placing the mic closer to the sound source will create a more pronounced stereo image while moving the mic further away will lessen the stereo image and result in more room noise. Placing a mic too close to a multi-voice source may result is some voices being more dominant than others. Use the low-cut filter switch to reduce stage floor noise and undesired low frequencies. Before operating, install an alkaline or mercury AA battery by unscrewing, and sliding down, the lower portion of the handle to reveal the battery compartment. DANGER: DO NOT USE PHANTOM POWER WITH THE CM-2S OR YOU COULD DAMAGE THE MICROPHONE. [. . . ] SPL (1% THD @1000HZ): 128dB S/N RATIO re 1Pa: 70dB Specifications and design subject to change for improvement purposes without prior notice. 03/09/04 [. . . ]