User manual NAD T741

[. . . ] T741 AV Surround Sound Receiver GB Owner's Manual GB 2 NOTES ON INSTALLATION. Avoid placing the unit in direct sunlight or near sources of heat and damp. Do not place it in an enclosed position such a bookcase or cabinet that may impede the air-flow through the ventilation slots. Red and white are Right and Left audio respectively, black for digital input, yellow for Video Composite and NAD Link. [. . . ] VIDEO 2 - Video 2 selects the signal from a TV/Satellite/Cable receiver or DVD player connected to VIDEO 2 as the active input. The Digital Input 2 is linked to the Video 2 Input (marked Digital In 2 on back panel; No. Digital Input 2 allows for connection of a digital source with an coaxial (RCA Jack) digital output. Whenever the corresponding digital input is activated, Digital Input 2 will also be selected; in the display the "DIGITAL 2" indicator will start to blink. If a digital audio signal is detected, the "DIGITAL 2" indicator will stop blinking and remain lit. If no digital audio signal is detected, "DIGITAL 2" indicator will cease blinking and extinguish. VIDEO 3 & VIDEO 4 - Video 3 & 4 select the signal from a TV/Satellite/Cable receiver, DVD player or VCR connected to VIDEO 3 or VIDEO 4 as the active input. "VIDEO-3" or "VIDEO-4" is shown in the Display Panel when selected. The Video 3 & 4 inputs also have video and analogue audio outputs specifically for recording video devices. The Digital Input 3 is linked to the Video 3 input (marked Digital In on back panel; No. Digital Input 3 allows for connection of a digital source with a Coaxial (RCA Jack) digital output. Whenever the corresponding digital input is activated, Digital Input 3 will also be selected; in the display the "DIGITAL 3" indicator will start to blink. If a digital audio signal is detected, the "DIGITAL 3" indicator will stop blinking and remain lit. If no digital audio signal is detected, "DIGITAL 3" indicator will cease blinking and extinguish. VIDEO OUTPUT - The video signal available on the S-Video and Video Composite outputs is dependent on the selected video input (VIDEO-1, VIDEO-2, VIDEO-3, VIDEO-4, VIDEO-5). However, when one of the audio-only sources is selected (FM, AM, CD, Tape Monitor or Ext. 5. 1) the last selected video signal from one of the video inputs will be present on these outputs. This way you can watch a DVD player or video whilst listening to the CD player. The display indicates which video signal is routed to the MONITOR OUT sockets (No. TAPE MONITOR Selects the output from a tape recorder when playing back tapes or monitoring recordings being made through the Tape sockets. Press the TAPE MONITOR button once to select it and again to return to the normal input selection. The Tape Monitor function does not override the current input selection. For example, if the CD is the active input when Tape Monitor is selected, the CD signal will continue to be selected and is sent to the Tape Out, Video 3 and Video 4 Out sockets. [. . . ] Pressing the TEST button engages the Test signal generator to allow for adjustment of all speaker levels, so that each channel can be adjusted for equal loudness at your listening position. The test signal scrolls automatically with 2 second intervals from Left, Center, Right, Rear Right, Rear Left, to sub-woofer in continuous cycles. If an adjustment in set-ting is made for one of the speakers, scrolling will stop until 2 seconds after the adjustment was made. The display panel shows which speaker is being fed with the test signal. [. . . ]