User manual NAD SR8 ADDENDUM

[. . . ] USING THE SR 8 REMOTE CONTROL LIBRARY The SR 8 can store a different library of default NAD codes for each of its DEVICE SELECTOR "pages. " If the original default library does not control your NAD CD player, DVD player or other components, follow the procedure below to change the library code. [. . . ] 2 While holding down the device button (CD), press "2" and "2" using SR 8's numeric buttons. The CD device selector will flash once to indicate that the library input is successful. RESET THE SR 8 TO ITS DEFAULT SETTINGS The SR 8 can be restored to its factory settings, including default libraries, by the following procedures 1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds until the AMP device button lights up. 2 Within two seconds of the AMP device button lighting up, release both buttons. If the reset mode is successful, the [CD] device button will flash twice. TABLE OF LIBRARY CODES APPLICABLE TO SR 8 REMOTE CONTROL LIBRARY CODE 10 11 20 21 22 23 31 40 41 42 NAD PRODUCT DESCRIPTION Default library for "AMP" page Zone 2 Default library for "CD" page; C 515BEE, C 545BEE, C 565BEE T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE T 513, T 514, T 515, T 517 T 587 IPD 2 Default library for "TUN" page; Tuner section of C 725BEE, T 175, T 737, T 747, T 755, T 765, T 775, T 785 C 422, C 425 C 445 SVENSKA NEDERLANDS NOTE The SR 8 may not necessarily contain all the control buttons applicable for the above-mentioned NAD products. [. . . ] Use the prescribed remote control of the specific NAD product for a full compliment of the applicable remote control buttons. DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH [. . . ]