User manual NAD SR 8 ADDENDUM

[. . . ] Two AA batteries should be fitted in the battery compartment at the rear of the Remote Control handset. When replacing batteries, check that they have been put in the right way round, as indicated on the base of the battery compartment. When a command from the remote control is received, the Standby LED indicator will blink. [. . . ] 6 MUTE: Press the [MUTE] button to temporarily switch OFF the sound to the speakers and headphones. MUTE mode is indicated by the Standby LED indicator flashing for NAD Integrated Amplifiers or "Mute" shown in the VFD of NAD Receivers. Mute does not affect recordings made using the TAPE output but will affect the signal going to the PRE OUT output. 7 DIM(forusewithNADStereoReceiver, TunerandCDPlayer): Reduce, turn off or restore VFD brightness. Depending on the NAD model, the brightness of the front panel display will vary when you toggle this button. 10 5 6 7 8 9 SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS 3, 4 ENGLISH ADDENDUM SHEET FOR SR 8 REMOTE CONTROL 8 VOL[ ]: Press [ ] button to increase or decrease the loudness level. For NAD Receivers, the VFD will also show "Volume Up" or "Volume Down" while pressing SR 8's [ ] buttons. The VOLUME buttons do not affect recordings made using the TAPE output but will affect the signal going to the PRE OUT output. 9 SPKA, SPKB: The [SPK A] and [SPK B] buttons engage or disengage the speakers connected respectively to the Speakers A and Speakers B terminals. Toggle [SPK A] to switch ON or OFF the speakers connected to the Speaker A terminals. Toggle [SPK B] to switch ON or OFF the speakers connected to the Speaker B terminals. These buttons are compatible only with specific NAD Receiver or Tuner models and do not apply to the C 355BEE. 10 TONEDFT: Tone controls are enabled or disabled by pressing this button. CDPLAYERCONTROL(forusewithNADCDPlayer): Set the DEVICE SELECTOR to "CD" in order to gain access to these buttons. Some of the control buttons below are applicable only to specific NAD CD Player models; check the owner's manual of your NAD CD Player for control button compatibility. TUNERCONTROL(forusewithNADAM/FM/DABTuner): Set the DEVICE SELECTOR to "TUN" in order to gain access to these buttons. Refer to the corresponding labels printed in the remote control faceplate and their respective assigned buttons to make use of these functions. Some of the control buttons below are applicable only to specific NAD Receiver or Tuner models; check the owner's manual of your NAD Receiver or Tuner for control button compatibility. [. . . ] RESET THE SR 8 TO ITS DEFAULT SETTINGS The SR 8 can be restored to its factory settings, including default libraries, by the following procedures 1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds until the AMP device button lights up. 2 Within two seconds of the AMP device button lighting up, release both buttons. If the reset mode is successful, the [CD] device button will flash twice. [. . . ]