User manual NAD PP1

[. . . ] INSTALLATION & OPERATION OF NAD PP 1 · Please make sure all ancillary equipment is turned off, and that the NAD PP 1 is not yet connected to its dedicated Power Supply. · Connect the leads from the turntable to the input sockets on the back of the NAD PP 1. [. . . ] · If the lead from your turntable is equipped with a separate earth lead, connect this directly to a ground connection on the amplifier or receiver. Usually, the metal back panel of an amplifier provides grounding by means of a small terminal. If this is not available, you can connect the earth cable directly to the back panel, by means of placing the wire under a screw in direct contact with the metal of the back panel; for instance, the screw holding the lop cover to the back panel. Almost all receivers provide a ground terminal with the antenna input; this terminal is usually marked 'GND' or with the symbol "---|---". If an antenna is connected, you can simply add the wire to this terminal. · Connect the dedicated Plug-in Power Supply to the NAD PP 1 (marked 15V). · Insert the Plug-in Power Supply to a live mains socket; the green LED on the NAD PP 1's front panel will light up. As the power consumption of the NAD PP-I is negligible, it can always be left switched on. It is recommended however that you disconnect the Plug-in Power supply from the mains if you are not going to use the NAD PP 1 for a prolonged period of time (such as a holiday). To play a record: · Ensure that the volume on the amplifier or receiver is set to a low level. [. . . ] 04% +/-0. 5dB 135 x 35 x 70 mm NAD ELECTRONICS LTD DESIGNED AND ENGINEERED IN LONDON. ENGLAND MODEL: PP 1 PHONO PRE-AMPLIFIER _______________ CUSTOM MANUFACTURED TO NAD SPECIFICATIONS NOTE: NAD reserves the right to change specifications or design at any time without notice. [. . . ]