User manual NAD C556

[. . . ] 6 Carts and stands - When placed or mounted on a stand or cart, the mounted to a wall As these colors may not correspond with the colored markings identifying unit should be moved with care. The terminals in your plug, proceed as follows: • The BLUE wire uneven connected to the terminal marked with the overturn or fall. Must be surfaces may cause the unit and cart to 7 letter ‘N’or colored BLACK. Wall or ceiling mounting - The unit should not be mounted on a wall or ceiling, thin an equilateral • The BROWN wire must be connected toInstructions. [. . . ] OWNER’S RECORD For your convenience, record the model number and serial number in the space provided below. Please refer to them when you contact your dealer in case of difficulty. Sence of duct’s enclosure ute a risk of letter ‘L’ or colored RED • When replacing the fuse, only a correctly rated and approved type WARNING! aPPLIANCE TO RAIN OR MOISTURE IF IN DOUBT CONSULT A COMPETENT ELECTRICIAN. Angle is intended operating e literature This product manufactured to to comply with the This product isis manufacturedcomply with the radio radio interference interference requirements of EEC DIRECTIVE 2004/108/EC. Requirements of EEC DIRECTIVE 89/68/EEC and 73/23/EEC round the unit than is equal to, ark of NAD Electronics International, a division of Lenbrook Industries Limited 08, NAD Electronics International, a division of Lenbrook Industries Limited РУССКИЙ The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. sVENSKA he plug fitted is ble is too short approved mains plug is ediately , to avoid mains supply. If s to be fitted, then EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. NEDERLANDS DEUTSCH TRIC SHOCK, OISTURE AND SHOULD NOT BE power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug The materials can be reused in accordance with their markings. If it still other forms of recycling of old re-use, recyclingtryraw materials, or does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. Products, you are making an important contribution to the protection of Avoid defeating the our environment. Safety feature of the polarized plug, do not force it into a power outlet. 3 AC power cord - When disconnecting the AC power cord, pull it out by the AC Your local administrative office can advise you of the responsible waste power plug. Power cords should be routed to avoid being severely bent, pinched, or walked upon. Pay particular RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) attention to the cord The model and serial to the power socket. 355BEE overloading AC outlets and extension from the unit number of your new C Avoid are located on the back of the cabinet. Cords beyond their capacity, as this could result in fire or record these numbers here: 4 Extension cord - To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug Model number : . 5 When not in use - The primary method of isolating the turntable from the mains supply is to disconnect the mains plug. Unplug the AC power cord from the AC outlet if the unit will not be used for several months or more. [. . . ] Stylus tip 2 Adjust the cartridge position in the head-shell so that the stylus tip is vertically aligned with the front of the hole marked A. 3 Ensure the cartridge is sitting square in the head-shell before fully tightening. 4 Set the Bias adjustment slider to the same number as the tracking weight. CONNECTING THE C 556 Use the external phono leads to connect the C 556 to an amplifier. [. . . ]