User manual NAD C520

[. . . ] Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. The unit should be installed so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through its ventilation openings. The unit should be situated from heat sources such as radiators, heat registers, stoves or other devices (including amplifiers) that produce heat. [. . . ] To use the digital output, connect a cable from this NAD 4 Two vertical bars indicate that the player is in PAUSE. In STOP mode the display reverts to showing the number of tracks and total playing time of the disc. `no diSC' glows in the display when no disc is present or when you load a disc that cannot be read (because it is dirty or is upside-down). REPEAT ONE glows in the upper-left corner during repeat-play of a single track. REPEAT ALL glows during repeat-play of the entire program or disc REMAIN glows in the top centre area of the display if you have pressed the TIME button to show the remaining time in the disc. As each track is played its number is blanked out on the Track Listing, giving a simple indication of how much of the disc has been played and how much remains. An infrared sensor, located at the right-hand portion of the display window, receives commands from the remote control. There must be a clear line-of-sight path from the remote control to this window; if that path is obstructed, the remote control may not work. The TIME button has two modes, as follows: TIME: the elapsed time since the beginning of the current track, in minutes and seconds. (This is the `default' setting, selected automatically when the player is turned on. ) REMAIN: the total playing time that remains until the end of the disc and the total number of remaining tracks (including the current track). This button stops play, cancels any repeat-play cycle, and re-sets the pickup to the beginning of the disc. The display reverts to showing the number of tracks and total playing time on the disc. Press the Repeat button once to select the REPEAT ONE mode, in which only the current track is repeated over and over again. Pressing the Repeat button once again selects the REPEAT ALL mode, in which the entire disc is played from beginning to end, over and over again. Press the Repeat button a third time to cancel the repeat cycle and return to normal operation. Press this button to open the disc drawer, and press it again to close the drawer. If this button is pressed while a disc is being played, the playback will stop, the pickup will re-set to the beginning of the disc, and the drawer will open. When the disc drawer is open, the drawer-closing mechanism can also be activated by pressing PLAY or by gently pushing the drawer inward. When the drawer closes, the player scans the disc's `table of contents' and displays the number of tracks and total playing time on the disc. If you press PLAY to close the drawer this display is skipped, and play commences immediately at Track 1. Press RANDOM either from the Stop or the Play mode and the C520 will play the tracks on the CD in random order until all the tracks have been played. [. . . ] Make sure that the input selector on your amplifier or receiver is set to CD. The CD player is subject to vibration or physical shock from external sources. A "humming sound can be heard NO use productos convencionales de limpieza de discos LP (soluciones de limpieza, rociados, paños tratados o preparaciones antiestáticas), ni use clase alguna de disolvente químico (alcohol, bencina, etc. Anslut signalkabeln som följer med NAD C520 till utgången märkt LINE OUT på CD-spelaren till CDingången på din förstärkare. [. . . ]