User manual NAD C320BEE

[. . . ] 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference. 3 Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. 4 Follow Instructions - All operating and use instructions should be followed. [. . . ] Do not place it in an enclosed position such a bookcase or cabinet that may impede the air-flow through the ventilation slots. 2 Power/Standby/Protection LED - Upon switching the power on, the LED will light up red for a few seconds before the protection circuit is deactivated. The LED will then turn amber, and the amplifier is ready for normal operation. In cases of serious abuse of the amplifier, such as overheating, excessively low loudspeaker impedance, short circuit etc. The amplifier will engage its Protection circuitry, indicated by the LED turning from green to red, and the sound being muted. In such a case, turn the amplifier off, wait for it to cool down and/or check the speaker connections, making sure the overall loudspeaker impedance doesn't go below 4 ohms. It is motor driven and can be adjusted from the remote control handset. The VOLUME control does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out). On the remote control handset, press the MUTE button to temporarily switch off the sound to the speakers and headphones. Mute does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out). REAR PANEL CONNECTIONS 1 IR Input / output - This input is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow control of the C320BEE from a remote location. 2 Disc input - Input for additional line level input signals such as CD, Mini Disc player or the output signal from a step-up amplifier for a turntable. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. Use a twin RCA-to-RCA lead to connect the CD player's left and right `Audio Outputs' to this input. 4 Video input - Input for the audio signal from a stereo VCR (or stereo TV/Satellite/Cable receiver) or other line-level audio source. Using twin RCA-to-RCA leads, connect to the left and right `Audio Outputs' of the unit to these inputs. 5 AUX input - Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. Use a twin RCA-to-RCA lead to connect the tuner left and right `Audio Outputs' to this input. 7 Tape 2 In/Out - Connections for analogue recording and playback to an audio tape recorder of any type. Using twin RCA-to-RCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE 2 IN sockets for playback and tape monitoring. Using twin RCA-to-RCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE 1 IN sockets for playback and tape monitoring. [. . . ] If one sets this switch to DEV 2, then the transport keys will remain as CD control keys irregardless of the position of the Tap/Tuner -CD switch. NOTES: The remote control handset supplied with the C320BEE is of a universal NAD type, designed to operate several NAD models. Some buttons on this handset are inoperative as the functions aren't supported by the C320BEE. Direct sunlight or very bright ambient lighting may affect the operating range and angle for the remote control handset. [. . . ]