User manual NAD C315BEE

[. . . ] 1 2 3 4 5 6 7 read instructions - All the safety and operating instructions should be read before the product is operated. Retain instructions - The safety and operating instructions should be retained for future reference. heed warnings - All warnings on the product and in the operating instructions should be adhered to. Follow instructions - All operating and use instructions should be followed. [. . . ] As these colours may not correspond with the coloured markings identifying the terminals With a mains plug, or one has to be fitted, then follow the instructions given below: Warning The Terminals marked with this symbol are hazardous live. External wiring connected to these terminals requires installation by an instructed person or the use of ready-made leads or cords. Avoid placing the unit in direct sunlight or near sources of heat and damp. Do not place it in an enclosed position such a bookcase or cabinet that may impede the air-flow through the ventilation slots. Ensure that leads and sockets are not damaged in any way and all sockets are firmly pushed home. If the unit is not going to be used for some time, disconnect the plug from the AC socket. Should water get into your NAD C315BEE, shut off the power to the unit and remove the plug from the AC socket. Have the unit inspected by a qualified service technician before attempting to use it again. 3 headphone socket :A 1/4" stereo jack socket is supplied for headphone listening and will work with conventional headphones of any impedance. Inserting a headphone jack into this socket automatically switches off the loudspeakers. the volume , tone and balance controls are operative for headphone listening. Use a suitable adaptor to connect headphones with other types of sockets, such as 3. Green LEDs just above each button will indicate which input is currently selected. TAPE Selects the output from a tape recorder when playing back tape recordings being made through the Tape sockets. 5mm stereo plug is inserted into the MP socket, the indicator above the socket will illuminate, and the DISC line-level source will be disconnected. It is recommended to mute the volume or switch to a different input before plugging/ unplugging the external Media Player cable 5 infra-red remote control command receiver :The infrared sensor, located behind this circular window, receives commands from the remote control. There must be a clear line-of-sight path from the remote control to this window; if that path is obstructed, the remote control may not work. 6 tone controls :The NAD C315BEE is fitted with BASS and TREBLE tone controls to adjust the tonal balance of your system. The 12 o'clock position is `flat' with no boost or cut, and an indent indicates this position. The Tone controls do not affect recordings made using the Tape outputs but will affect the signal going to the Speakers. 7 tone defeat : The TONE DEFEAT switch by-passes the tone control section of the NAD C315BEE. If the Tone Controls are not normally used and left in the 12 o'clock position, then it is advisable to switch out the Tone Control section altogether by using this switch. [. . . ] Engages CD drawer Open/Close; Press once to open the CD drawer then once again to close the CD drawer and start playback. Power AC lead unplugged or power not switched on · Check if AC lead is plugged in and power switched on · Place unit away from direct sun, reduce amount of ambient light · Turn amplifier off, make sure ventilation slots on top and bottom of amplifier are not blocked. IR receiver in direct sun or very bright ambient light Treble Bass Continuous output power into 8 2 Rated distortion (THD 20Hz - 20kHz) Clipping power (maximum continuous power per channel 4 and 8) IHF Dynamic headroom IHF dynamic power (maximum short term power per channel) ±5dB at 10kHz ±8dB at 100Hz 40W (16dBW) 0. Dimensions (W x H x D) 6 Net weight Shipping weight Net Gross 435 x 70 x 242mm 435 x 80 x 292mm 5. [. . . ]