User manual NAD 710

[. . . ] Any mounting of the device on a wall or ceiling should follow the maufacturer's instructions and should use a mounting accessory recommended by the manufacturer. Quick stops, excessive force and uneven surfaces may cause the appliance and cart combination to overturn. Read and follow all the safety and operating instructions before connecting or using this unit. All warnings on the unit and in it's operating instructions should be adhered to. [. . . ] Using twin RCA-to-RCA leads or a SCART/RCA Adapter, connect to the left and right `Audio Out' of the unit to these inputs. Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. A ribbon wire FM antenna is included and should be connected to the FM connector at the rear of the unit using the `balun' adapter supplied (see fig 1). the ribbon aerial should be mounted on a vertical surface and placed so that it forms a `T'. Experiment with placement of the antenna to find the position that gives the best signal strength and lowest background noise. An inadequate FM signal normally results in high levels of hiss, especially in stereo, and interference from external electrical sources. The tuner section's performance can be improved by using an externally mounted FM antenna. A qualified aerial installer will be able to advise and fit a recommended aerial for your reception conditions. Using twin RCA-toRCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE IN connectors for playback and tape monitoring. The `RIGHT+' terminal should be connected to the `+' terminal on your right-hand loudspeaker and the `RIGHT-' connected to the loudspeaker's `-' terminal. connect the terminals marked `LEFT+' and `LEFT-' to the left-hand speaker in the same way. Always use heavy duty stranded wire or specialist speaker cables to connect the loudspeakers to your NAD-710. The high-current binding post terminals can be used as a screw terminal for cables terminating in spade or pin connectors, or for cables with bare wire ends. These should be slotted under the terminal's screw bushing, which is then fully tightened. Ensure the connector is tightly secured and there is no danger of bare metal from spade connectors touching the back panel or another connector, as this may cause damage. Bare wires and pin connectors should be inserted into the hole in the shaft of the terminal. Unscrew the speaker terminal's plastic bushing until the hole in the screw shaft is revealed. Insert the pin or bare cable end into the hole and secure the cable by tightening down the terminal's bushing. Avoid any danger of bare metal from the speaker cables touching the back panel or another connector. Ensure that there is only 1/2" (1cm) of bare cable or pin and no loose strands of speaker wire. Your NAD-710 has additional front panel PLAY/RECORD connectors to playback or record using a second system temporarily connected to the receiver. [. . . ] The FM STEREO indicator lights when a stereo FM station is being received and the NAD-710 is switched into STEREO mode. First select the AM or the FM band using the AM/FM button and then press the Mode switch until the PRE- Each time these buttons are pressed, the display panel will flash for a few seconds showing the Preset number and the Presets frequency. You can store a new station into a used Preset by simply going through the Preset storing process and placing a new station over the existing one. Portable mode selected and unit connected to the Portable is playing in addition to another selected input. [. . . ]