User manual NAD 515

[. . . ] HOW TO CONNECT A PLUG The wires in the mains lead are coloured in accordance with the following code: BLUE ­ "NEUTRAL" ("N") and BROWN ­ "LIVE" ("L"). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured BLACK. The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured RED. Do not connect either wires to the earth terminal in the plug which is marked by the letter "E" or by the safety earth symbol or coloured green or green-andyellow. [. . . ] See `CALLING UP INFORMATION ON THE DISPLAY' if you wish to see other information on the display. ­ You can also press PLAY (6) immediately after inserting the CDs; the compartment then closes automatically and play starts from the first available CD. ­ Use the PREFERRED POSITION in the CD compartment if you wish to insert only one CD and then start play by pressing the QUICK PLAY button (14). ­ You can interrupt playback by pressing PAUSE(9); PAUSE then lights up. ­ If you press PLAY during play, the current track will start again from the beginning. ­ If you press OPEN (3) during play, the CD compartment will open while play continues. The three CDs outside the changer may now be changed without playback being interrupted. The searching speed is determined by how long a key is pressed: ­ the first 2 seconds fairly slowly, with sound; ­ then at the maximum speed, with no sound. If you reach the end of the last track and release , play will resume a few seconds before the end of the CD. You can also select the number by using the NEXT DISC button 8 on the remote control. First select the number of the required CD using DISC (13) or DISC (8) on the remote control. You can also select the track number by using the 1-10 digit keys (3) on the remote control (numbers consisting of two figures must be keyed in within 2 seconds). ­ The music stops and a moment later the selected track begins to play. ­ SHUFFLE lights up and all the tracks are now played in a random order. (5), you will select any one of · If you wish to know the total playing time of the entire CD you must go back to STOP mode first and then press TIME. ­ The display now shows the number of tracks and the total playing time of the current CD (TOTAL TIME). ­ REPEAT (1) lights up; the track will now be repeated continuously. repeating a CD: · Press REPEAT (10) twice before or during playback of the CD. ­ REPEAT DISC lights up; the CD will now be repeated continuously. repeating all CDs: · Press REPEAT (10) three times before or during playback. ­ Repeating a track is not possible in SHUFFLE mode or when a programme is being stored. ­ When a programme has been stored (for one or more CDs), then only the programme will be repeated. [. . . ] Under no circumstances should you repair the changer yourself as this will invalidate the guarantee!Leave the CD changer in a warm environment until the moisture evaporates. The distance between remote control and CD changer is longer than 10 metres. ­ REPEAT(1) se ilumina: the track will now be repeated continuously. [. . . ]