User manual MURRAY 6291490X54

[. . . ] In addition, a hazard symbol may be used to represent the type of hazard. DANGER indicates a hazard which, if not avoided, will result in death or serious injury. WARNING indicates a hazard which, if not avoided, could result in death or serious injury. CAUTION indicates a hazard which, if not avoided, might result in minor or moderate injury. [. . . ] (Figure 10) If the top of the cables (5) have become disconnected from the drive levers (6), attach the cables (5) to the "Z" fitting (7). Read this Instruction Book and safety rules before operation the snow thrower. Compare the illustration with your snow thrower to familiarize yourself with the location of various controls and adjustments. WARNING: Always stop the engine before unclogging the discharge chute or the auger housing and before leaving the snow thrower. (Figure 13) Push the remote chute lever (2) forward to discharge the snow high and far. Do not exceed the maximum amount of air pressure shown on the side of the tire. (Electric Start) Connect the power cord to the switch box (11) located on the engine. (Electric Start) Plug the other end of the power cord into a three-hole, grounded 220 VOLT, A. For the number of times required to push the primer button (9), see the engine manufacturer's instructions. (Electric Start) Push on the electric start button (10) until the engine starts. (Recoil Start) Slowly pull the recoil starter handle (12) until resistance is felt and then pull rapidly to start the engine. If the engine does not start in 5 or 6 tries, See the "Trouble Shooting Chart" Instructions. as the engine warms up , adjust the choke control (14) toward the RUN position. (Electric Start) First disconnect the power cord from the three-hole receptacle. NOTE: In temperatures below 05F (-185C), allow the engine to warm up for several minutes before blowing snow. When throwing snow, always run the engine with the throttle control (13) in the fast position. WARNING: Never run the engine indoors or in enclosed, poorly ventilated areas. engine exhaust contains carbon monoxide , an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts located on the engine or the snow thrower. To stop the engine, move the throttle control (3) to the stop position and remove the safety key (8). CAUTION: To stop the engine, do not move the choke control to CHOKE position. To stop the engine, push the throttle control lever (13) to off and remove the safety key (8). [. . . ] Measure the distance (7) between belt guide (8) and traction drive belt (4). If an adjustment is necessary, loosen belt guide (8) and set the distance (7) for belt guide (8) to 3/16 inch (4. WARNING: Do not remove gasoline while inside a building, near a fire, or while you smoke. If the snow thrower is to be stored for an extended period, refer to the engine manufacturer's operating manual (included with some models) for important maintenance or storage details. [. . . ]