User manual MURRAY 6240810X54

[. . . ] This warranty is effective for the time periods and subject to the conditions stated below. for warranty service , find the nearest Authorized Service Dealer in your area. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at www. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ] After the front wheels (1) are installed, lift the tractor from the support. (Figure 8) When mounting the top of the grass bag (9), hold the bottom of the grass bag (9) slightly away from the rear plate (14). (Figure 10) Then, lower the grass bag (9) until the bottom is against the rear plate. Also, the wrong air pressure will keep the mower housing from cutting level. The correct air pressure is: Front Tires 0, 97 BAR (14 PSI), Rear Tires 0, 69 BAR (10 PSI). If the mower housing does not cut level, see the instructions on "How To Level The Mower Housing" in the Maintenance section of this instruction book. If the battery (1) is put into service before the battery date, the battery cables can be attached without charging the battery (1). If the battery (1) is put into service after the battery date, the battery (1) must be charged. Fasten the seat (1) to the seat hinge (2) with the fasteners (4) and (5). Slide the seat (1) forward or backward along the seat adjusting holes (3). See the engine manufacturer's instructions for the type of petrol and oil to use. WARNING: Do not ride up or down slopes that are too steep to back straight up. Before you add petrol, stop the engine and let the engine cool for several minutes. If the height of the grass is more than 31/2 inches (9 cm), cut the grass with the mower housing in the highest position. You can also cut at 1/2 to 2/3 of the full cutting width of the mower housing. These components tell the electrical system if the operator is sitting on the seat. NOTE: The engine will not start unless you depress the clutch/brake pedal and move the blade rotation control to the DISENGAGE position. Move the throttle control completely forward to the CHOKE or FAST position. NOTE: If the engine does not start after four or five tries, move the throttle control to the FAST position. To start a hot engine, move the throttle control to a position between FAST and SLOW. This will extend the life of the product and is also necessary to maintain warranty coverage. Check the spark plug, drive brake, lubricate the unit, and clean the air filter once a year. [. . . ] A correct replacement part or assistance is available from an authorized service center in your area. Make sure the steering shaft assembly (3) is inside the motion drive belt (1). Pull the belt retainer (1) away from the idler pulley (2) and remove the mower drive belt (3). Pull the belt guide (4) and the brake assembly (7) away from the mandrel pulley (5) and remove the mower drive belt (3). [. . . ]