User manual MURRAY 6210701X61

[. . . ] This warranty is effective for the time periods and subject to the conditions stated below. for warranty service , find the nearest Authorized Service Dealer in your area. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at www. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ] If the battery (1) is put into service before the , the battery cables can be attached without charging the battery (1). If the battery (1) is put into service after the , the battery (1) must be charged. If a piece of wood cannot be found, get another person to help lift the tractor. Bend the ends of the cotter pin (5) appart to keep the front wheel (1) on the spindle (3). After the front wheels (1) are installed, lift the tractor from the support. If the mower housing does not cut level, see the instructions on "How To Level The Mower Housing" in the Maintenance section of this instruction book. If you do not have a battery charger, have an authorized service centre charge the battery. See the engine manufacturer's instructions for the type of petrol and oil to use. Before you use the unit, read the information on safety, operation, maintenance, and storage. WARNING: Follow the engine manufacturer's instructions for the type of petrol and oil to use. Fasten the seat (1) to the seat hinge (2) with the fasteners (4) and (5). After each use, clean the bottom and top of the mower housing for better performance. These components tell the electrical system if the operator is sitting on the seat. NOTE: The engine will not start unless you depress the clutch/brake pedal and move the blade rotation control to the DISENGAGE position. Move the throttle control completely forward to the CHOKE or FAST position. NOTE: If the engine does not start after four or five tries, move the throttle control to the FAST position. To start a hot engine, move the throttle control to a position between FAST and SLOW. See the engine manufacturer's instructions for the type of petrol and oil to use. If necessary, add oil until the oil reaches the FULL mark on the dipstick. Before you add petrol, stop the engine and let the engine cool for several minutes. For a lawn to look better, check the cutting level of the mower housing. Daily or before each use After completion of first 5 hours After 25 hours For wear or burn out c. [. . . ] (Figure 19) To remove the motion drive belt (1) from the stack pulley (2), pull the front end of the belt under the stack pulley (2) and then back between the stack pulley and the steering plate (3). A correct replacement part or assistance is available from an Authorized Service Centre in your area. Make sure the steering shaft assembly (3) is inside the motion drive belt (1). CAUTION: If the unit is operated in dry areas that have sand, use a dry graphite spray to lubricate the unit. [. . . ]