User manual MURRAY 465618X51

[. . . ] This warranty is effective for the time periods and subject to the conditions stated below. for warranty service , find the nearest Authorized Service Dealer in your area. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at www. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ] See the engine manufacturer's instructions for the type of petrol and oil to use. Before you use the unit, read the information on safety, operation, maintenance, and storage. WARNING: Follow the engine manufacturer's instructions for the type of petrol and oil to use. If you do not have a battery charger, have an authorized service centre charge the battery. Fasten the seat (1) to the seat hinge (2) with the fasteners (4) and (5). NOTE: If the engine stops when you engage the blade(s), the seat switch is not activated. Before you leave the operator's position, make sure the blade(s) has stopped rotating. Before you ride the unit across a sidewalk or a road, move the blade rotation control (1) to the DISENGAGE position. WARNING: Always keep your hands and feet away from the blade, deflector opening, and the mower housing when the engine runs. NOTE: In cold weather, the heavy viscosity oil in the transmission will make the unit difficult to push. To use the lights with the engine running, turn the key to the position for the lights. When you mow large areas, start by turning to the right so that the cut grass will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left turns until finished. If the grass is very high, cut two times to decrease the load on the engine. First cut with the mower housing in the highest position and then lower the mower housing for the second cut. For better engine performance and an even discharge of the cut grass, always operate the engine with the throttle in FAST position. When you use a bagger, operate the engine with the throttle in FAST position and the speed control pedal pushed 1/3 to 1/2 forward. After each use, clean the bottom and top of the mower housing for better performance. WARNING: Do not ride up or down slopes that are too steep to back straight up. To reduce forward speed when going down a hill, slowly release the speed control pedal until the unit slows to the desired speed. Before you add petrol, stop the engine and let the engine cool for several minutes. These components tell the electrical system if the operator is sitting on the seat. [. . . ] CAUTION: If the unit is operated in dry areas that have sand, use a dry graphite spray to lubricate the unit. Pull the belt retainer (1) away from the idler pulley (2) and remove the mower drive belt (3). Pull the belt retainer (4) away from the right mandrel pulley (5) and remove the mower drive belt (3). Pull the belt retainer (4) away from the left mandrel pulley (6) and remove the mower drive belt (3). [. . . ]