User manual MURRAY 405327X51

[. . . ] IMPORTANT: The following pictorials are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the product that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. [. . . ] To change the cutting height, raise or lower the lift lever (5) as follows. Move the lift lever (5) forward to lower the mower housing and back to raise the mower housing. When you ride on a sidewalk or road, move the lift lever (5) to the highest position and move the blade rotation control to the DISENGAGE position. Use the throttle control (7) to increase or decrease the speed of the engine. For normal operation and when using a grass bagger, move the throttle control to the FAST position. For maximum charging of the battery and for a cooler running engine, operate the engine in the FAST position. The speed control pedal (1) will automatically return to the NEUTRAL position and the unit will stop. Before you start the engine, make sure the blade rotation control (1) is in the DISENGAGE position. To push the unit, use the automatic drive disconnect (1) to release the transmission. As you release the parking brake, push the speed control pedal to the desired speed. The parking brake must be disengaged before the speed control pedal is able to engage the transmission. Move the throttle control completely forward to the CHOKE or FAST position. NOTE: If the engine does not start after four or five tries, move the throttle control to the FAST position. To start a hot engine, move the throttle control to a position between FAST and SLOW. IMPORTANT: When you operate with the mower housing, always operate with the throttle control in the FAST position. In high or thick grass, cut the grass in the highest position first and then lower the mower housing to a lower position. NOTE: When you mow in heavy grass or mow with a bagger, use a slow forward speed. If the mower housing does not cut level, see the instructions on "How To Level The Mower Housing" in the Maintenance section. See the engine manufacturer's instructions for the type of petrol and oil to use. If necessary, add oil until the oil reaches the FULL mark on the dipstick. For a lawn to look better, check the cutting level of the mower housing. For the mower housing to cut level, make sure the tyres have the correct amount of air pressure. [. . . ] A correct replacement part or assistance is available from an Authorized Service Centre in your area. The replacement parts are shown either on the back pages of this Instruction Book or in a separate Parts List Book. use only manufacturer's authorized or approved replacement parts. Do not use attachments or accessories not specifically recommended for this unit. [. . . ]