User manual MURRAY 405028X51

[. . . ] IMPORTANT: The following pictorials are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. If you understand the unit and how the unit operates, you will get the best performance. To help prevent an accident, follow the operating instructions and the safety rules. [. . . ] In high or thick grass, cut the grass in the highest position first and then lower the mower housing to a lower position. NOTE: When you mow in heavy grass or mow with a bagger, put the shift lever in the slowest speed. If you need to go faster or slower, stop the unit and move the shift lever to another speed setting. If the mower housing does not cut level, see the instructions to "Level the Mower Housing" in the Maintenance section. When on a slope or in a turn on a hill, move the throttle control to the SLOW position to help prevent an accident. Check the Oil NOTE: The engine was shipped from the factory filled with oil. See the engine manufacturer's instructions for the type of petrol and oil to use. If necessary, add oil until the oil reaches the FULL mark on the dipstick. Before you add petrol, stop the engine and let the engine cool for several minutes. Fill the fuel tank (1) to the FULL (2) position with regular unleaded petrol (see Figure 6). Move the throttle control completely forward to the CHOKE or FAST position. NOTE: If the engine does not start after four or five tries, move the throttle control to the FAST position. To start a hot engine, move the throttle control to a position between FAST and SLOW. For a lawn to look better, check the cutting level of the mower housing. For the mower housing to cut level, make sure the tires have the correct amount of air pressure. After completion of first 5 hours After 25 hours For wear or burn out c. This will extend the life of the product and is also necessary to maintain warranty coverage. Check the spark plug, drive brake, lubricate the unit, and clean the air filter once a year. Follow the Maintenance section to keep the unit in good operating condition. Before you make an inspection, adjustment, or repair to the unit, disconnect the wire to the spark plug. Remove the wire from the spark plug to prevent the engine from starting by accident. When you hold the blade, use gloves or cloth material to protect your hands. [. . . ] The correct air pressure is: Front Tires 0, 97 BAR (14 PSI), Rear Tires 0, 69 BAR (10 PSI). To remove the motion drive belt (1) from the stack pulley (2), pull the front end of the belt under the stack pulley and then back between the stack pulley and the steering plate (3) (see Figure 19). A correct replacement part or assistance is available from an authorized service center in your area. Pull the belt retainer (1) away from the idler pulley (2) and remove the mower drive belt (3) (see Figure 10). [. . . ]