User manual MULTICOAT MULTI-TEX STUCCO

[. . . ] This system combines an elastomeric waterproofing membrane (MULASTICOAT) with a fiberglass re-inforced, synthetic resin modified cementitious top coating (KRETE KOTE 2000 or TOP COAT 2000). The SLATEX ABOVE GRADE SYSTEM is designed to withstand heavy foot traffic on decks, ramps, walkways, etc. [. . . ] The SLATEX ABOVE GRADE SYSTEM can be applied to concrete, wood, magnesite and most other surfaces or substrates in need of a waterproofing and/or fire resistant protective coating. FLASH ALL EDGES AND CAULK PLYWOOD JOINTS ADVANTAGES G Low Cost - Minimum Down Time - Easy to Apply G Superior Waterproofing G Hard, Durable, Anti-Skid Surface G Maintains Surface Integrity Over Minor Substrate Movement G Excellent Weather-Salt-Fire Resistance G Superior Bonding to Substrate G Excellent Freeze-Thaw Resistance G High Impact and Abrasion Resistance G Waterbase - Environmentally Safe to Use and Apply SEE TEST DATA MULASTICOAT POLY FAB EMBEDDED IN MULASTICOAT OVER JOINTS/FLASHING. TWO COATS MULASTICOAT OVER ENTIRE SURFACE. ROLL OR TROWEL DOWN FIRST COAT OF KRETE KOTE AND EMBED FIBERGLASS MESH. SURFACE PREPARATION All substrates, concrete or wood, must be structurally sound, free from all grease, oil, paint, dirt, dust, sealers, curing compounds, and other foreign materials which may prevent proper bonding. Substrates should be constructed in compliance with all applicable building codes. Plywood substrates, including tongue and groove plywood, must be 5/8" minimum thickness, exterior grade CC PTS plywood, 16" maximum support spacing, edges blocked, all fastened with 8 penny ring shank nails or equivalent, on maximum 6" centers. (NOTE: Plywood must be nailed on all four sides. ) Moisture content should be below 15%. CONCRETE SUBSTRATE Open cracks with a crack chaser to 1/4" and clean out dust and residue. All expansion or control joints must be cut and cleaned out and filled with approved caulking material. "Instructions for use. ") Allow minimum 24 hour cure before allowing foot traffic and minimum 72 hours before allowing vehicle traffic. COVERAGE MULASTICOAT (waterproofing membrane): 40 to 50 sq. per gallon (2 coats). LIMITATIONS Do not apply any components of the SLATEX SYSTEM when substrate surface temperature is below 50°F, above 100°F, if ambient temperature is below 50°F and falling, over 100°F and expected to rise, or if precipitation is expected within a 24 hour period. PACKAGING AND STORAGE MULASTICOAT - furnished in 1 and 5 gallon containers, 55 gallon drums and 275 gallon totes. Shelf life is approximately 24 months in unopened bags and approximately 18 months in unopened pails. WARRANTY Materials are guaranteed with respect to uniformity and quality within manufacturers' specifications. Seller makes no other warranty, expressed or implied, regarding the use of its products. Since use of the product is beyond Seller's control, the Buyer assumes all risks of use. Seller's sole obligation shall be to replace material if found to be defective. [. . . ] Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or consequential, resulting from use of its products. COLORSEAL (Recommended) Apply two coats of COLORSEAL (Refer to COLORSEAL TEST DATA-- SLATEX SYSTEM (Above Grade) TEST METHOD RESULTS 1. [. . . ]