User manual MULTICOAT ICF STUCCO SYSTEM

[. . . ] The system adds an elastomeric waterproofing membrane (MULASTICOAT®) with a synthetic resin modified cementitious top coating. ( KRETE KOTE 2000 or TOP COAT 2000) The METAL LATHE WATERPROOF SYSTEM is designed to withstand heavy foot traffic on decks, ramps, walkways, etc. [. . . ] The METAL LATHE WATERPROOF SYSTEM can be applied to concrete, wood, magnesite and most other surfaces or substrates in need of a waterproofing and/or fire resistant protective coating. Staple metal lathe to deck MULTI-BASE applied, covering wire lathe ADVANTAGES · · · · · · · · · Low Cost - Minimum Down Time - Easy to Apply Superior Waterproofing Hard, Durable, Anti-Skid Surface Maintains Surface Integrity Over Minor Substrate Movement Excellent Weather-Salt-Fire Resistance Superior Bonding to Substrate Excellent Freeze-Thaw Resistance High Impact and Abrasion Resistance Water base - Environmentally Safe to Use and Apply MULASTICOAT applied SEE TEST DATA SURFACE PREPARATION All substrates must be structurally sound, free from all grease, oil, paint, dirt, dust, sealers, curing compounds, and other foreign materials which may prevent proper bonding. Substrates should be constructed in compliance with all applicable building codes. Plywood substrates, including tongue and groove plywood, must be 5/8" minimum thickness, exterior grade CC PTS plywood, OSB, or better 16" oc maximum support spacing, edges blocked, all fastened with 8 penny ring shank nails or equivalent, on maximum 6" centers. (NOTE: Plywood/OSB must be nailed on all four sides. ) Moisture content should be below 15%. NOTE: ALL ABOVE GRADE DECKS SHOULD BE PROPERLY VENTED. Ready for Finish Texture, and ACRATHANE COLOR SEAL KRETE KOTE/TOP COAT applied APPLICATION Lay out 2. 5 galvanized metal lathe in a staggered pattern over the entire plywood/OSB surface overlapping the metal flashing to the edge of the deck surface. Make sure the metal lathe joints do not mirror the plywood/OSB joints, minimum 6"away from any joint. Staple metal lathe with minimum 7/8" crown by a minimum 5/8" long corrosion resistant staple spaced 3"oc in the field and 1"oc in all metal lathe overlap joints, plywood joints and perimeter of the deck. ft per bag (1-2 coats) MULASTICOAT (waterproofing membrane): 40 to 50 sq. per gallon (2 coats). LIMITATIONS Do not apply any components of the SLATEX SYSTEM when substrate surface temperature is below 50°F, above 100°F, if ambient temperature is below 50°F and falling, over 100°F and expected to rise, or if precipitation is expected within a 24 hour period. PACKAGING AND STORAGE MULASTICOAT - furnished in 1 and 5 gallon containers, 55 gallon drums and 275 gallon totes. Shelf life is approximately 24 months in unopened bags and approximately 18 months in unopened pails. WARRANTY Materials are guaranteed with respect to uniformity and quality within manufacturers' specifications. Seller makes no other warranty, expressed or implied, regarding the use of its products. Since use of the product is beyond Seller's control, the Buyer assumes all risks of use. Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or consequential, resulting from use of its products. TEST DATA TEST METHOD RESULTS 1. [. . . ] Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or consequential, resulting from use of its products. TEST DATA TEST METHOD RESULTS 1. [. . . ]