User manual MTD TB25BP

[. . . ] Operator’s Manual 2-Cycle STOP ALTO GAS BACKPACK BLOWER Model TB25BP For problems or questions, DO NOT return this product to the store. Box 361131 Cleveland, OH 44136-0019 For Consumer Assistance Please Call Para La Ayuda Del Consumidor Llame Por Favor CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. 1-800-520-5520 Made in Taiwan / Hecho en Taiwan • • • • • SAFETY ASSEMBLY OPERATION MAINTENANCE PARTS LIST P/N 9096-MD1802 PRINTED IN TAIWAN Operator’s Manual 2-Cycle STOP ALTO GAS BACKPACK BLOWER Model TB25BP For problems or questions, DO NOT return this product to the store. Box 361131 Cleveland, OH 44136-0019 For Consumer Assistance Please Call Para La Ayuda Del Consumidor Llame Por Favor CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. [. . . ] For normal stopping, release trigger and allow engine to return to idle speed. Then DEPRESS the OFF “STOP ” switch until the engine stops completely. 11 STARTING A WARM ENGINE (Engine has been stopped for no more than 15-20 minutes). Set throttle (see step 1 for starting a cold engine), chuck “3”, pull starter rope. If engine does not start, or starts and then stops after 5 rope pulls, follow procedure “STARTING A COLD ENGINE”. 16 ASSEMBLY INSTRUCTIONS ATTACH INTERMEDIATE TUBE AND CONCENTRATOR NOZZLE Connect the intermediate tube (H) and concentrator nozzle (I) or 56mm nozzle (J) (you can only use I nozzle at time). Push the tubes together and turn them clockwise so that they lock together (Fig. Use concentrator nozzle when you need more airflow in tight places: flower beds, under decks, etc. STARTING/STOPPING INSTRUCTIONS NOTE: The unit uses the Spring AssistTM starting system, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly--there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. 9) NOTE: If engine fails to start after repeated attempts, refer to Troubleshooting section. pulling starter at an angle will cause rope to rub against the eyelet. This could cause rope to snag or fray and also damage the starter assembly. ADJUST BACK PACK HARNESS AND CONTROL HANDLE Place blower on your back by slipping arms through the shoulder straps as if you were putting on a jacket (Figure 8). Once adjustments have been made, to the straps for user comfort, remove the blower from your back and place on level ground in an upright position. 13 STARTING/STOPPING INSTRUCTIONS STARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). Squeeze throttle (A) and push throttle lock (B) to advance throttle for starting. With the unit on the ground, hold the top assist handle and step on the bottom of the frame with foot. After warm up, If unit does not Idle after restarting 2 times, follow these steps to adjust idle. Using a Phillips or slotted screwdriver - turn screw 1/4 to 1/2 turn clockwise (to the right). [. . . ] € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer. € The following components are included in the emission related warranty: engine, air filter, carburetor, primer, fuel lines, fuel pick up/fuel filter, ignition module, spark plug and muffler. 5-13 6032-150-02 Description WASHER NUT SCREW HOUSING SCREW SCREW COVER SCREW FRAME WASHER NUT CUSHION BACK RIVET RIBBED HARNESS NUT WASHER SCREW ELBOW PIPE1 HOSE BEND WIRE CLAMP FLEX PIPE ACTIVE RING BASE PIPE MIDDLE PIPE END PIPE END PIPE THROTTLE LEVER ASS'Y WASHER LIGATE TAPE 18 MANUFACTURER’S LIMITED WARRANTY FOR: Manuel del Dueño/Operador The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purc hased and used in the United States, its possessions and territories. [. . . ]