User manual MTD OEM-290101 INSTALLATION INSTRUCTIONS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MTD OEM-290101. We hope that this MTD OEM-290101 user guide will be useful to you.


MTD OEM-290101 INSTALLATION INSTRUCTIONS: Download the complete user guide (1530 Ko)

Manual abstract: user guide MTD OEM-290101INSTALLATION INSTRUCTIONS

Detailed instructions for use are in the User's Guide.

[. . . ] This is a standard tow hitch design which can be used for attachments including the TROYBILT Sweep Cultivator. You may also use it with other attachments you already own, such as a lawn roller, four-wheel shredder, or a drag-mat. [. . . ] Refer to Photo 6 below showing the Tine Attachment in place on the Tine Cradle. If you do not have a Tine Cradle, you may instead prop up the Tine Attachment housing with a block of wood to keep the transmission housing level, thereby preventing gear oil from leaking out of the dipstick hole. CAUTION • Always handle the edges of the tiller hood carefully. • When an attachment is removed from the Power Unit, always place a wood block or other sturdy support beneath the coupling to prevent the attachment from falling forward. Figure 2: Insert both dust caps. Step 3: Install the Tow Hitch A. Align the hole in the right-hand corner of the Tow Hitch with the alignment pin at the PTO access hole. Note that the washers on the swing-bolts should be next to the bolt heads. Tighten the swing-bolts by alternating between the two bolts to achieve even tightness. Tighten the bolts securely, using a 3/4" wrench at least 11" long (this length provides sufficient leverage to tighten securely), until the concave washers on both bolts are flat. Or, if you have a torque wrench, tighten each bolt to 70-80 ft/lbs. Step 2: Use of Dust Caps A. Insert the smaller, 1-1/2 " dust cap into the PTO access hole, as shown in Figure 2, whenever the Power Unit is detached from the Tine Attachment. With the dust cap in place, the access hole is protected from the entry of dust, dirt and moisture. The dust cap may remain in place for the operation of non-powered attachments such as the Tow Hitch. It must, however, be removed before attaching the Tine Attachment or other powered attachments. [. . . ] Attachments that have only a single-tongue connection should not be used because they allow the Power Unit to tip forward or backward excessively and make the machine difficult to control. Some lawn rollers, harrows, and other drag-type attachments may come very close to you as you make sharp turns. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MTD OEM-290101




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MTD OEM-290101 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.