User manual MTD MHT1600

[. . . ] Such use of any attachment or accessory may increase the risk of injury to the user. Do not use appliance for any job except that for which it is intended. Ground Fault circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) to be used for the gardening appliance. Receptacles are available having built-in GFCI protection and may be used for this measure of safety. [. . . ] Extension cords of the type specified above are available at local hardware stores. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. To reduce the risk of disconnection of appliance cord from the extension cord during operating: Make a knot as shown in Figure 2; Volts Avoid dangerous environment. Water entering a power tools will increase the risk of electric shock. Use of rubber gloves and substantial footwear is recommended when working outdoors. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tools while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. Do not move 1 120V Ampere Rating More than Not more than Do not force tool. The correct tools will do the job better and safer at the rate for which it is designed. Disconnect the plug from the power source before making any adjustment, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. When not in use, tools should be stored indoors in dry, and high or locked-up lace, out of reach of children. Keep cutting tools sharp and clean for best performance and to reduce the risk of injury. inspect tool cord periodically , and if damaged , have it repaired by an authorized service facility. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual. The power supply cable should be checked regularly and before using it each time make sure the cable is not damaged or old out. Keep it away from the cutting area, from damp, wet or oily surfaces or with sharp edges and away from heat and fuels. [. . . ] Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. 3 CAUTION: Do not use the trimmer for cutting stems greater than 10mm. Use the trimmer only for cutting normal shrubbery found around houses and buildings. [. . . ]